Oldsmobile Ciera
Crankshaft Sensors
Ford Expedition XLT

Where would you locate the crank sensor on an 1988 Oldsmobile Cutlas Ciera?

Top Answer
User Avatar
Wiki User
Answered 2011-09-13 12:10:14

On my 1990 the crank sensor is behind the vibration dampner. I just replaced it last week.Cost $35.00 at Auto Zone. Just be careful because you have to align the veins on the back of the dampner to go in between the grooves of the sensor.

User Avatar

Your Answer

Still Have Questions?

Related Questions

1987 Oldsmobile cutlass ciera oxygen sensor location?

what is the oxygen sensor location on a 1993 oldsmobile cutlass ciera 3.3l v6

Where can you find a diagram of a fuse panel for a 1989 Oldsmobile Cutlas Ciera SL?

fuse panel 1992 Oldsmobile regency elite

How do you remove a knock sensor in an Oldsmobile cutlass ciera?

where is the knock sensor located on 93 cutlass ciera

Where is the map sensor on 90 olds cutlass ciera?

Where is the choke sensor on a 1991 Oldsmobile ciera 3.3L

How do you install sound system in a 1989 Oldsmobile Cutlas Ciera?

Look at for detailed pictures and instructions.

How Do You Replace A Headlight Switch In A 1993 Oldsmobile Cutlass Ciera?

how do you replace the headlight switch on a 1993 cutlas ceria*

Where is the starter on a 1994 Oldsmobile cutlass ciera?

The starter on a 1994 Oldsmobile Cutlass Ciera is located on the driver's side of the engine towards the bottom of the engine. It is behind the crankshaft sensor and the fusible links.

Where is the cam sensor located on a 94 Oldsmobile ciera cutlass s?

The 1994 Oldsmobile Cutlass cam sensor is located on the back of the left cylinder head. The cam sensor should be labeled as such.

Where is the speed sensor located on a 1996 Oldsmobile cutlass ciera?

It should Be located on the top of the transmission.

Where is the voltage regulator on a 1991 cutlas ciera?

It is built into the alternator.

Where is fuel filter located on 1988 olds cutlas cierra?

where is fuel filter located on 1988 olds cutlas ciera?

Where is 1996 Oldsmobile Cutlass Supreme Position Sensor Location?

where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine

Where is the crankshaft sensor located on a 1990 Oldsmobile cutlass ciera 2.5 l?

if its like my 87 olds ciera 4cyl its attached behind the ignition moduallType your answer here...

Change oxygen sensor on 95 Oldsmobile cutlass ciera?

Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.

Where Tps located on an 1996 Oldsmobile ciera 3.1l?

wher is the TPS located on a 96 oldsmobile ciera 3.1L ?

Where is the oxygen sensor located in an 96 Oldsmobile ciera?

It is screwed into the manifold (4-cyl) or front exhaust pipe (V6).

Where is the horn relay located on a 95 olds cutlas ciera?

The 1995 Oldsmobile Cutlass horn relay switch can be found on the firewall in the engine compartment. The horn relay switch will be on the drivers side of the firewall.

Installing a turn light switat in 1995 Oldsmobile ciera?

how to installing a turn light switat in 1995 Oldsmobile ciera

Where is the signal flasher located on a 1987 Oldsmobile Cutlass Ciera?

Where is the signal flasher located on a 1987 Oldsmobile Cutlass Ciera?

How do you tighten a serpentine belt on a 1996 Oldsmobile ciera?

How do you tighten the serpentine belt on an oldsmobile ciera

Master flow sensor located on Oldsmobile cutlass ciera?

The "mass air flow" sensor would be located in the snorkel between the air filter box and the throttle body.

Where is the fuel pump in a 1987 Cutlas Ciera?

It is probably IN the gas tank. You will have to drop the gas tank to get to it.

What is drive belt length for 1991 Cutlas Ciera without bypass pulley and no AC?


How do you change the heater core on a 1989 Oldsmobile Cutlass Ciera?

How do you change the heater core on a 1989 Oldsmobile Cutlass Ciera? or where can I get the Info on replaceing it

How do you replace the speed sensor on a 89 Olds Cutlass Ciera?

Raise the vehicle and locate the speed sensor. Remove the electrical plug. Turn the speed sensor counterclockwise and remove it. Install the new speed sensor.

Still have questions?