answersLogoWhite

0


Best Answer

According to the explided view that I obtained from the local Kia dealer, the caliper pin with the relieved area and rubber sleeve goes in the upper position on the caliper

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Which bolt goes to the top 2000 Kia sportage cailper bolt?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much 134a goes in 2000 Kia Sportage?

2 cans i think, i cant find my spec sheet.


Will a 2000 Honda Civic bumper fit on a 1997 Honda Civic?

no it will not fit... cuz the holes where the bolt goes does not match....


Do you have to replace both oxygen sensors at the same time on a 2000 Kia Sportage?

no you do not, but rule of thumb is if one goes out the other one is right behind it, nod nod ,wink ,wink.


What nicknames does Bolt Birch go by?

Bolt Birch goes by Bolt.


What kind of freon goes in a 2002 Kia Sportage?

134-A is correct for this mod!


What nicknames does Usain Bolt go by?

Usain Bolt goes by Lightning Bolt.


What part of a thermostat goes toward the engine?

the kia sportage 2000 thermostat, they is a small open hole seats on the plate just like the one in the centre where does it face when u put the thermostat in the housing Generally the spring of the thermostat goes towards the engine block.


What size of bolt goes in the water pump of a 83 yz80?

which bolt


Is Mittens in the movie Bolt in love of Bolt during the movie Bolt goes on?

I Think She Sorta Is But Im Not Sure.


What does Usain Bolt do to prepare himself?

goes to the toliet


Where is the speed sensor in a 2000 ford ranger?

AnswerIt is in the top of the rear differential. (thats what your driveshaft goes into in your rear axle.)its just held in by one small bolt. Comes right out easily. The speed sensor goes into the top of the rear axle toward the front.


2000 dodge grand caravan the big pin that goes threw the differential gears shot threw the housing how does this happen?

The bolt that holds that pin in fails. This can be caused by spinning tires or bad luck.