I would recommend at least Grade 8, just to make sure.
Look on the lower end of the engine Should have 2 mounting bolts
Depends On What The Starter Is From. Car Model Engine Size, Or Mounting Bolts Ect. If It Is The Bolts That Assemble The Starter< You Can Get These At A Starter Alternator Shop. The Mounting Bolts. Drop By The Dealer Parts House They Can Fix You Up.
The mounting bolts that attach the compressor to the engine.
If you had any recent engine work, ask them to check out your mounting bolts. You should always get new bolts every time. If not, it may be your RPM's are running a little low at idle. You can take it to any automotive garage and have a new idle programed and an oil change should do.
I have a 1998 Chrysler Voyager and to change the water pump I found that after loosening the bolts there was simply not enough space between the engine and the engine side wall to get it out. The solution is simply to put a jack under the engine to support it, then remove the engine mounting bolts and use the jack to lift the engine enough to get the water pump out from the top of the engine. Then put the new one in, tighten the bolts and put on the belt again. Then lower the engine and put on the engine mounting bolts.
The 1994 Toyota pickup truck starter mounting bolts can be found on the head of the starter. There will be three mounting bolts.
Should be 2 mounting bolts at the rear of caliper
There should be 4 bolts on bottom of the engine, make sure they are still there and tighten them, they can loosen up or even fall off.
Engine mounts on 1997 Crown Vic are under the engine above the front frame cross member. There are three bolts that attach the mount to the engine, and two bolts that connect the mount to the frame mounting points.
you must lower rear of trans by removing crossmember and use along extension.gmjim
There are a lot of bolts on the engine and we don't know what bolts your talking about, there are different torque specs all over the engine, I would say that you should go to the library and get a chiltons repair manual for your car and it will tell you the specs your looking for.
155 ft. lbs. They are stretch bolts so you SHOULD replace them everytime.