It is a synthetic rubber gasket that prevents the bearing from losing its grease or being contaminated with dirt
2RS Mean 2 Rubber Seal
I used an SKF 30205J2/Q bearing and CR 692369 seal. Russ
Rubber.
the rubber seal is used to seal the car of from the outside so that you want hear any wind noise and you dont get wet when it rains from water leaking in
The job of the rear main seal is to keep the oil lubricating the rear main bearing from leaking out. Older model rear main seals were made from a "rope" type of material. Today the rear main seal is a one or two piece seal made from neoprene rubber and is located directly behind the rearmost main bearing journal of the crankshaft.
An O ring.
Rubber bungs of different sizes to seal/close test tubes/boiling tubes/conical flasks.
If this S10 is a 4+4, the seal and bearing is not serviceable. The hub and bearing assembly is replaced as one unit.
it is an internal retaining ring
They are pieces of metal, rubber, or cork that are used to seal two parts together.
Remove the tire and wheel. Remove the and to the axle. Remove the wheel bearing seal, with a seal puller. Remove the wheel bearing. Reverse the process to install the new wheel bearing.