Want this question answered?
remove resistor from loop positive to positive terminal neg to neg
Disconnect the neg. side and then the pos side of battery. Then to completely drain the power press brakes or press horn. Wait fifteen minutes and reconnect pos side then neg. side of battery.
The Sequoia has four oxygen sensors, two on each side. The ones in front of catalytic are pos 1 and after are pos 2. Bank 2 is on passenger side, Bank 1 is on the driver's side.
Both of the small posts (pos & neg) are primaries. The large connection is the secondary.
The resister cuts the voltage to 6v.. in run pos,Will send 12v to coil in start pos.
On a 94 Ford 7.3, the throttle POS sensor is on the throttle body. It is on the opposite side of the throttle linkage.
You do pos to one side to pos the other side on the sub then the same for negative then to the amp you hook the pos to one channel then the negative to the other channel and the same on the other sub and amp
"Pos T Vac, otherwise known as vacuum therapy, can be used alone or in conjunction with oral medications such as Viagra. It is FDA approved, and no harmful side effects have been documented in the use of the Pos T Vac."
hook both pos on one side and both neg on tha other
Use a jumper wire from the battery + (pos) terminal to the positive on the blower motor, and run a - (Ground) wire from ground on the motor, to chassis or frame.
My Mother was O pos. Dad was AB pos. Can I have a different blood type such as A pos? My siblings have AB pos.
Look under pass side by flywheel. it is probably on starter (if pos)