0
Which vehicle has a 53 inch drive shaft center to center of the drive shaft U-joint?
Wiki User
∙ 11y ago
98 chevy s10
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What length is the drive shaft for a 1969 dodge dart swinger with the 340 and 4 speed?
51.53 inches from u-joint center to u-joint center
How do you replace the rear drive-shaft on a 96 tacoma reg cab?
Remove 2 small u-bolts from rear end yoke Pry drive shaft out of yoke Slide front end of drive shaft off front splines
Where is the drive shaft?
where is the driveshaft on a 2005 Ford Ranger
Is a drive shaft anything to do with a crank shaft?
well a cranks shaft u need a hand to pump its the same as petrol because when u pump it A WIERD SUBSTANCES EJACULATES FROM IT :)
What is drive shaft run out?
we can drive shaft run out thriugh the dail indicator. 1. put the dail indicator at shaft 2.checking 3.marking at 4 section. 0 , 90 ,180 ,270 4.chek clearance 5.check bearing surface 6.check earw ring check shaft cracking
What is carrier bearing?
The carrier bearing is located in the center of a two piece drive shaft. It holds up the center of the drive shaft. The drive shaft extends from the rear of the transmision to the rear drive axle (differental). The two piece drive shaft and the carrier are needed when there is a large angle between the transmission and the differental. The carrier bearing keeps the drive shaft up high under the vehicle.
What is a carrier bearing?
The carrier bearing is located in the center of a two piece drive shaft. It holds up the center of the drive shaft. The drive shaft extends from the rear of the transmision to the rear drive axle (differental). The two piece drive shaft and the carrier are needed when there is a large angle between the transmission and the differental. The carrier bearing keeps the drive shaft up high under the vehicle.
Why does the rear ujoint keep blowing out from the driveshaft to the axle?
A worn pinion flange or the drive shaft where the u-joint goes in these holes may be wallered out some
Where is the propeller shaft no a Nissan Sentra 2003?
I dont believe a 2003 Sentra has a propeller shaft because it is a front wheel drive vehicle. Only rear wheel drive vehicles truly have a propeller or DRIVE shaft. It runs down the center of the vehicle, length ways, connecting the output end of the transmission to the input end of the differential.
Can you change a 1993 4l80e transmission to a 4x4?
The center shaft in a 2-wheel drive transmission is shorter then a 4-wheel drive transmission because the 2-wheel drive does not have a transfur case on the back of it. NOW, You can take the center shaft out of the 4-wheel drive trans. and install it in the 2-wheel trans. and it will now work in the 4-wheel drive vehicle. To change the center shaft requires both transmission to be taken all the way apart.
How do you remove the drive shaft on a 1999 Ford f150 Ford?
Chock the wheels to be sure vehicle will not roll. Mark the differential and drive shaft before removing drive shaft. Remove 4 bolts from differential-end of drive shaft. Place a pan under the transmission-end of drive shaft and have clean rags handy. Push the drive shaft slightly toward the front of the vehicle while pulling downward on the drive shaft and lower it to the ground. Pull the drive shaft toward the rear of the vehicle until the front of the drive shaft pulls out of the transmission. Place the drive shaft on the ground and put rags in the transmission to prevent oil leakage and keep dust/dirt out. Assemply is reverse of removal with special attention to aligning marks on the drive shaft to the mark on the differential.
What does a drive shaft typically do?
A drive shaft is found in a frnt-wheel drive vehicle. It runs from the engine and gearbox to the front wheels. The engine generates energy, known as torque. The drive shaft carries the torque to the wheels forcing them to rotate, thus moving the vehicle.
How safe is it to drive a vehicle when the drive shaft is broken or faulty?
never drive any vehicle with a worn universal joint, you may cause serious injury to yourself or other drivers when the drive shaft lets loose on the road
What is a center bearing?
That is a bearing in the centre of a crankshaft or drive shaft.
What would happen if the half shaft and intermediate shaft separated?
The vehicle would no longer move on its own unless you have a 4 wheel drive vehicle.
How do you take the center supporter off the front drive shaft?
You have to remove the drive shaft and take to to a machine shop. It has to be pressed off Rob
How can you tell if a Cadillac SRX 4 wheel drive or 2 wheel drive?
Check the sticker under the hood near the center of the vehicle, it should show "all wheel drive" if it is all wheel drive, or look under the vehicle to see front axels and wheel drive shafts and rear drive shaft and rear end "pumpkin"
