0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you change a wheel stud on a 1995 1500?
HOW DO YOU CHANGE FRONT WHEEL STUDS ON A 1995 CHEVY LUMINA AUTOMOBILE?
How do you change front wheel stud on Chevy 1992 s10 blazer?
The front wheel stud on a 1992 Chevy Blazer S10 can be changed by jacking the vehicle up, removing the wheel, and unbolting the caliper. The rotor assembly can then be removed, and the wheel stud pressed or hammered out of its seat.
How do you change the rear stud on a 2001 Acura 3.2 CL Type S?
If by stud you mean wheel stud you have to remove the bearing and have a shop take it out or rent a press and press it out yourself because wheel studs are pressed onto the wheel bearing.
How long does it take to change a wheel stud on your own?
Depends on your ability and the vehicle in question.
Does the rims on a 1999 Honda odeyssa fit 1999 Chevy suburban?
Not hardly, It will not work. Wheel stud patterns are different.
Change front wheel stud bolt on driver side on 99 Chevy lumina?
Wheel studs are just pressed in. Pound out the old one. Put the new one in. Slip a large nut over the stud.....one that just slides on, not screws on. Now put one of the original lug nuts on. Start tightening until the lug stud is pulled into the hub as original. Remove lug nut and large nut. That's it.
How much will it cost to replace a broken wheel stud in a 2000 Chevy Silverado?
Did it on a 4Runner at a Firestone Tire Shop. They charged my $15 for the part and $50 Labor. Rear wheel.
How do you change the front wheel rotor on a 2000 Chevy cavalier?
Remove the wheel,remove the brake caliper, it may have a clip on the lug nut stud, just grab it with needle nose plires and twist it till it breaks off and then the rotor should just fall off.
How do you replace broken stud on 95 f 150 4x4?
Are you asking about a wheel stud or exhaust stud, please clarify
How do you change the rear wheel studs on a 1990 f150?
remove the wheel then the brake drum then tap out the old studs with a hammer and pull in the new stud with some washers to protect the threads and tightening the nut until the stud is fully home reinstall the drum and the wheel and torque bolts and you are done good luck
How do you change a stud for Chrysler sebring 98?
I am assuming you mean for a wheel. You take the wheel off and the caliper and then finally the brake disc. pound out the busted stud through the other side. Be carefull not to hit the wheel bearing. insert the new stud and then using a huge C- clamp, tighten it into postion. Get a Chilton or Haynes manual for like 15 bucks, they tell how to do this and a whole lot more.
Stud pattern for Mitsubishi lancer 1992?
1992 Mitsubish lancer wheel stud pattern?
