Want this question answered?
A wheel bearing is pressed in to the hub so that it is able to safely operate. To replace a bearing on a Chevy Impala remove the hub from the car and take the unit to a machinist. Have the press out the old bearing and press in the new one.
It's a sealed unit with the hub. You have to replace the whole hub assembly.
No.
You can replace both... Bearing or Hub... Bearings are cheaper, but harder to find and replace. Hub assemblies are easier to replace, but slightly more expensive.
If, after close inspection you do not see any damage to hub, you can use it. But ALWAYS install new bearing race with bearing.
a hub is what the wheel bolts to on the car.the hub bearings are the bearings that allow the hub to turn on the axle. most times they are called axle bearings,
The front wheel bearing is a sealed unit with the wheel hub - replace the hub and wheel bearing unit. Remove the four bolts from the rear of the steering knuckle that connect to the hub bearing unit.
the wheel speed sensor is all part of the wheel bearing hub assembly you cannot clean them you have to replace the hub assembly its not that hard of a job gm cars are known for this problem.
The front bearing for a Dodge Stratus is attached to the Hub. To replace it remove all the components on the hub assembly. There are three bolts that hold the assembly in place. Loosen the bolts and pry out the hub. Replace the unit.
Front is easy, just replace hub rear is pressed in
nO
It's easy, you have to replace the entire hub!When the bearings go bad, you have to replace the whole hub! Simple! It's easy, you have to replace the entire hub!When the bearings go bad, you have to replace the whole hub! Simple!