0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How would you know the abs module is bad?
Certain codes would lead to a bad ABS module.
Where is a restraints control module located at on a 2002 Mazda truck?
The module is located on the transmission hump in front of the gearshift under the dash. If you check under the cup holder, you will find two sets of wires going in and these will lead you to the module. The module also has the crash sensors built into it. Good luck
Can you bypass a gem module in your ford f150?
yes. you just have to know what wires lead to and which ones to connect together
Where is transmission control module on a 1994 Dodge Intrepid?
find the wiper fluid fill and fuse panel, you will see the power control module, and transmission control module, bolted together, normally gray in color, all wires lead to the boxes, so it cant be hard to find
WHERE IS A 1997 Chevrolet S-10 ABS?
Follow the brake lines from the master cylinder, they will lead you right to the ABS module.
Would a faulty ABS module lead to my 1999 Passat stalling?
I don't see how. The ABS system is designed to fall safe, ie, off.
Will a harley soft tail run with a bad ignition module?
It totally depends upon what is wrong with the ignition module. The ignition module's job is to know when the correct time is to send current to the ignition coil. This is what generates the "spark" in the plugs. If the module is not sending current to the coil, no spark, and thus no go. If the module is sending weak current to the coil, the spark will be weak, and that will lead to poor starting, underpowered performance, unburned gasoline getting to your exhaust, and other nastiness. If the ignition module is not firing at the correct time, then that is even worse; that can lead to pinging, knocking, incomplete combustion, lack of power, burned up pistons. Ignition modules also can become "heat" or "cold" sensitive, where they will run intermittently or not at all when they have warmed up, or when they are cool. So, the short answer is "maybe, but it isn't good."
How do I locate the ignition module on a 1990 Chevy Celebrity?
The ICM is located on the passenger side, up under the dashboard. Remove the glove box and you can see it. It will be bolted to the side panel It is held on by 2 bolts, one on top, one on bottom. Disconect battery before removing! The above is the location of the engine control module or computer. If your car has the V6: The ignition control module is mounted to the lower part of the engine block on the radiator side of the engine. If you follow the spark plug wires down they will lead you to it. The coils are bolted to the ignition control module. If your car has the 4 cylinder engine: The ignition control module is below the intake manifold towards the rear of the engine. The spark plug wires will lead you directly to it. The coils are mounted on the ignition control module. It is in a awkward spot to get to.
What is hierarchy chart in computer programming?
Chief Executive OfficerVice President Senior Project Manager / Senior Product Manager / Senior Software Architect Project Manager / Product Manager / Software Architect Project Lead / Senior Team Lead / Senior Technical Lead Module Lead / Team Lead / Technical Lead Senior Software Engineer / Senior QA Engineer Software Engineer / QA Engineer
Location of ignition module on 1988 Chevy silverado 2500 350 engine?
Follow the 2 pin connector from the top of the coil located on the driver side front of the distributor. It should lead to a 2 pin connector, as well as a 4 pin connector. This is the ignition control module.
What is module moi in french?
Me Module
What causes dash security light to flash even when driving 2002 GMC Sierra 1500?
The security module has gotten confused. To correct, disconnect the the hot lead of the battery for about 3 minutes and then reconnect it. This resets the module and the light should not be on until the remote security lock button is pressed.
