I was told that only one bulb fit the high mount tail lamp socket by both the repair people and the parts store. There are, however, 2, lamps that fit that socket. If you use the wrong bulb, the dash panel indicator lamp stays on after you push the brake pedal.
AnswerIf the light does not come on until the first time you push on the brake pedal after starting the car it means you have a burnt brake light bulb, most times its the brake light bulb in the back window.Not as front signals.
we have turn signals but no back up brake or warning signals we get power to signal switch on transmission but not beyond that point should this modual be changed keep in mind that this is a 1981 ford f150 and if this modual is changed will that help?
There are several way of getting across a warning signal. For example, hand signals, alarms, and code phrases are good means of low-key communication.
If you don't have turn signal lights then you must use hand signals.
Yes it had turn signals.
Turn signal flasher?
Absolutely not. Before flashing lights were put on cars, hand signals were all that was available to indicate a turn. In fact, hand signals were once required (in Louisiana, at least) even if your vehicle had flashing signal lights. It's important to know and be prepared to use hand signals in the event your signal lights malfunction. Source: common sense
All Interstates are limited access and do not have traffic signals.
Check the Hazard warning switch
may have a bad signal switch,or may be a blown fuse
its the engine diagnostics warning light which tell you have a fault following a audio signal and visual signal saying some kind of fault. its the engine diagnostics warning light which tell you have a fault following a audio signal and visual signal saying some kind of fault.
The cornering lights are tied in with the turn signals - they'll come on automatically IF the turn signal is used.