0
Why after replacing a turn-signal switch and lever assembly on a 1996 cavalier there's no auto-cancel when using the right signal but when using the left signal it works fine?
Wiki User
∙ 17y ago
Either the unit is broken, or the cam is off center on the steering column, reacting much quicker to left turns than to right turns.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Replace hub assembly on a 2001 Cavalier?
how do i replace the hub assembly on a 1997 cavalier 2.3 Ls
How much does oil gasket replacement cost for a 1996 Chevy cavalier?
what are the signs for replacing the oil gasket in a 1996 Chevy cavalier
Should you have to replace the seal when replacing wheel hubs on a 97 cavalier?
YES.
99 cavalier right front turn signal replacement?
Reach behind the bumper of the 99 Cavalier. There are two nuts that hold the turn signal assembly in. Remove the nuts to take the assembly off and replace it.
Where is the headlight socket located on a 1996 cavalier?
It is at the rear of the headlamp assembly where the wires are.
Is the front wheel bearings on 2001 cavalier compressed?
part of the hub assembly
1997 cavalier will not start after alternator change?
did you unhook the battery before replacing the alternator
How do you repair a sunroof in cavalier?
The sunroof on a Chevy Cavalier can often be repaired by replacing the outer seal. This prevents rain from leaking into the vehicle and causing additional problems.
Where is the kill switch on a 1996 cavalier?
The ignition switch, or "killswitch," for a 1996 Chevy Cavalier is located inside the steering column. Replacing or repairing it requires disassembly of the steering column.
Replacing the engine in z24 cavalier?
unless you have a complete shop and you are a machanic don't even try by yourself
What does lash mean when your replacing a head on a 97 Cavalier?
lash usually means a gap, clearance, play ,ect.
How do you change wheel bearings on 1998 cavalier?
Both the front and rear bearings on a 1998 Cavalier are contained in the hub assembly. The rear hub is attached with four bolts, and the front with three.
