0
Why are my day time running lights and low beam lights not working but my high beams work on my 2000 sunfire gt?
Wiki User
∙ 14y ago
I have a 98 sunfire gt and i have only high beams which only switch on sometimes and no low beams just day lights my shop told me it could be wiring or turn signal switch they looked and determined it was the switch so i just ordered it. They can be found on carpartwholesale.com or autopartwarehouse.com for only 30 or 70 with cruise control. only need a torx wrench and small screwdriver to replace it just snaps into the wiring harness.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why do the high beams not work even though running and normal beams work fine on 2001 Sunfire?
Does the car have fog lights? I have a 2003 Sunfire that the high beams would not work on. This was caused by a short in the fog light wiring. I had the fog lights rewired separate from the harness (about $100) and the problem was fixed.
If the high beams on a 1998 Sunfire do not work but the daytime running lights do is it because they are on the same element?
Seperate circuits I believe.
Daytime running lights and low beams not working on 2004 trailblazer Everything else working fine?
check your fues
Why would the daytime running lights on your 97 Jetta the daylight stop working if the low and high beams work?
check fuse for the running light module.
03 Dodge Dakota daytime running lights not working and killing power to high low beams and interior lights how do I fix?
i have the same problem.did you find out what it was? maintenance@rescraft.com
Why wont the daytime running and low beams lights work when I have high beams and have changed both lights and the switch?
Have you checked the drl relay?
2000 Chevy Cavalier low beams do not work but day running lights and high beams work what could be wrong?
As a guess both low beams are burnt out The daytime running and high beams are the same light filament. Or the fuse or the relay for the low beams.
Why would my headlights quit working but the parking lights brake lights and tail lights still work and high beams do when switch is pulled back on a 94 Grand Am?
Low beams are burned out.
How do you fix the daytime running lights on a 99 sunfire GT. its not the bulbs or the cluster?
I had a similar problem where just one of the daytime running lights didn't work, this was also accompanied by one of the high beams not working. The wiring for that circuit is exposed too much and is subject to corrosion. Test the wiring at different points until you find the short, or see the corroded wires. Once you find the problem , its an easy cut-and-repair job. Hope that helps.
What could be the cause of your high beam lights working and the low beams not on your Chevy Malibu?
These lights have 2 different "lights" in each of them. This occurs frequently. Change out the bulb and everything will be working fine once again.
What if 2000 Lexus ES300 High beams not working checked bulbs high beam stalk switch possibly a relay where is the relay?
I have the HID headlights for low beam and the halogen lights for high beams. The halogen lights also serve as daytime running lights. I noticed one day that the running lights weren't working and the high beams weren't either. I traced the problem to the light bulb socket--seemed one of the connectors in the socket had gotten hot and melted the socket. I replaced the socket (passenger side) and both started working (evidently they are wired in series). After about 7 months I noticed them off again. I looked and the same socket (passenger side) had melted again. I went to the auto parts place and bought a "heavy duty" socket and replaced it again. After 1 year they are both still working.
What will cause the dim lights not to work when on but bright lights work and the daytime running lights changed the dimmer swith still not working?
Im Assuming you Should Check The Whole Lighting System. Usually it NOT the switch but could be. suprised me once when it was, but again usually not. The Daytime lights a separate from the Regular beams, check the high and low beams next before anything else. maybe just an old light that decided to Crap out?
