Drum braked models have self adjusting rear brakes. The adjusters are crap design and often don't work. Take a look at the rear shoes and see how the adjusters work.... clean the adjusters and ensure everything is operating as it should. Apply a small amount of high melting point grease to the adjusters. Re-assemble the brakes and pump the brake pedal to engage the adjusting mechanism. That's it!! have fun.
Yes - Provided that the self adjusters have not seized from rust. That is quite common with drum brakes. Some year Sables have rear disc brakes. Those self adjust also. The Taurus /Sable rear disc adjusters are just as bad at seizing from rust as the drum adjusters. -On occasion I've even had to remove them and fit a whole new adjuster.
The rear aren't easy since you have the self adjusters and parking brake mechanisms to contend with. Get a manual from the parts sore.
reverse then hit the brakes hard do this a few time and the self adjusters should adjust for you
They are self adjusting. You don't have to adjust them. Problem is the wear limit on the drum is only 1mm. When worn to the limit the adjusters don't work.
Self-adjusters for drum brakes expand as the brake shoes wear so the gap between the shoes and the drum remains roughly constant throughout the life of the shoes. They are almost always located at the bottom of the brakes, separating the two shoes. Teeth on the gear of the self-adjusters engage with a metal tab when you apply the brakes. As the brakes wear, the metal tab turns the gear and causes the self-adjusters to unscrew and expand. Make sure when installing self-adjusters that you buy the adjuster for the correct side of the car. The left and right side adjusters are threaded in opposite directions. If you put the wrong one on the wrong side, it will tighten instead of expand and eventually your brakes will not work correctly.
No! If the self adjuster isn't working you will either need to replace them of fix them because it takes stopping the weight of the vehicle for the adjusters to work.
Look under vehicle on Passenger side towards rear (just in front of rear wheel) you can see the adjusters on the cables there. use spanner to adjust. Look under vehicle on Passenger side towards rear (just in front of rear wheel) you can see the adjusters on the cables there. use spanner to adjust.
They are self adjusting. The wear limit on the drums is only 1mm, and the minimum lining is 1mm, so if you have these limits, the adjusters are on the limit and won't work. However they may be seized.
no, the valves are self adjusting using hydraulic lash adjusters.
Yes, there is a left side and right side adjuster.
not likely!! problem is probably adjusters stuck !!on rear brakes,if the adjusters were not stuck then whenever you back up they should adjust them selves.