0
I'm going to assume this question was asked thinking that someone was saying world holes and it was misheard. World holes occur in minecraft multiplayer when information about a chunk does not get sent to the client properly. Those with poor or slow connections will notice a lot more world holes than those without. World holes can be fixed by logging out and back in to the server.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Screw holes on distributor cap are stripped?
As the screw holes on the distributor caps are used to hold the cap down, when stripped, the cap could be JB Weld. ?æRe-drill the screw hole once the weld cures.
How do you weld holes in catalytic converter?
A catalytic converter with holes in it needs replacing. It affects not only emissions, but the performance of the engine. Replace the converter.
What is a straight weld bead on the surface of a plate with little or no side to side electrode movement called?
A narrow, straight weld bead that is created by moving the SMAW electrode straight along the weld joint. A quality stringer bead should have good tie-in on both sides of the weld.
What is weld defect?
Under cut: groove formed along the edges of welding bead, thereby reducing the thickness of base metalCracks: Discontinuity in the weld zonePorosity: Holes in the weld metal caused by the entrapment of gasSlag inclusion: An entrapment of slag or other foreign metal actually inside the weld metalLack of penetration: Lack of weld metal actually entering the parentLack of fusion: Lack of thorough and complete mixing between filler metal and base metal
Is their a oversize bushing kit for 2003 S-10 door hinge. already have a bushing kit in it. holes on door hinge ova-led?
I remove the door, weld up the holes and redrill them to the correct size.
What is the name around the weld that becomes adversely hot?
its called flux
What is splatter in welding?
Splatter is drops of metal in and around the weld area.
How to repair a aluminum livestock trailer?
You will probably need too weld any holes in your aluminum livestock trailer. It is best to higher a professional welder as this can be very dangerous.
What is 7 welding defects?
Under cut: groove formed along the edges of welding bead, thereby reducing the thickness of base metalCracks: Discontinuity in the weld zonePorosity: Holes in the weld metal caused by the entrapment of gasSlag inclusion: An entrapment of slag or other foreign metal actually inside the weld metalLack of penetration: Lack of weld metal actually entering the parentLack of fusion: Lack of thorough and complete mixing between filler metal and base metal
How close can one weld be to another weld?
Depends on what you are welding, but generaly welds can meet, or even weld on top of a weld.
Undercutting in welding?
A proper weld is produced as the rod is moved across the material, and the flame at the end of the rod cuts a path in the material and that path is refilled by the material of the rod. It flows back into the cut out filling it and joining the materials. If the welder is too hot, or the persons technique is incorrect, or they are moving the rod to fast, the the path cut by the flame on the end of the rod is not properly filled, and the result is an undercut running along the side of the weld. This undercut causes the weld to be weak and makes it susceptible to failing. Undercutting is easy to correct and requires practice by the welder to get the flame temperature and the speed right so as to fill the path that is cut until full. The opposite being going to slow and making a humped up weld. A proper weld will be slightly over the surface of the original part, smooth with no pits or holes, and no undercutting.
Who is Theodore Weld?
Theodore Weld
