The throttle cable may be broken.
The throttle plate is inside the throttle body on the intake manifold. The throttle cable from the accelerator peddle is connected to the throttle plate shaft on the throttle body. If you remove the air cleaner hose at the throttle body, you will see the disc shaped plate.
A throttle positioning sensor reads your throttle body to see how much your pressing the gas basicly. So if its bad the engine runs up and down not knowing exactly how much peddle is being pushed.
check the switch at the break peddle
the throttle cable come in two pieces unless you want to replace the whole thing from the peddle up. the cable rest on the back of your intake and runs towards the left on your firwall and into the firewall box..
by using peddle
Peddle is a verb.
I had the same problem..... Throttle position sensor .... Mine was defective and was telling the computer that the gas peddle was down all the time....
Julian Peddle was born in 1955.
A homophone for "peddle" is "petal."
I peddle my handmade jewelry at the local market on weekends.
This depends when the noise happens:When you hold the clutch peddle down, this is the "Throw out bearing" also known as release bearing, getting ready to seize and ruin your clutchWhen you step on the peddle, this is usually a dry pivot or cable, there are pivots (3) in the peddle itself and may be several more on the way to the clutch.
check the cruise motor to is just above the peddle A rusty/tight throttle body. It should be by the oil dipstick + oil fill cap.