Take wheels off and check, no use speculating.
Try checking the power steering fluid. My taurus did the same thing until i filled the power steering fluid.
did you put high quality brakes on your car if so then it is normal do not worry about it. even if not some brakes just squeak all the time
Computer controlled
The Ford Taurus has a 55 - 45 front - rear weight distribution. Because of the engine and other crucial components, the Ford Taurus is considered to be front heavy and may under-steer at time.
form_title= Ford F150 Brakes form_header= Drive safely with new brakes. When was the last time your brakes have been replaced?*= _ [50] Have you noticed any issues?*= () Yes () No Do you have to press hard on the brakes?*= () Yes () No
(Harmony2k3) If you have the following issues then I would have them checked: (do they squeak every time they are wet? do they squeak at all when they are dry? when you push your brake pedal is it spongy and go to the floor? do you have to pump your brakes? has it been more than a year since you've had brake service?) If you said yes to any or all of those questions then I would have them looked at.
That a tough one being that they started making the Taurus in 86 Maybe you ment 87? and like myself have lexdiscsik fingers? but basicly do one side at a time and referance the unassembled side. Take pictures too. Good luck Jerre
Occasionally, new brakes will squeak or squeal for a short time as the pads get "bedded in." But in general, brake pads that are properly installed should not squeak, especially with new rotors installed at the same time. Usually, one of the following components is used to PREVENT squeaky brakes: --brake pads with built-in shims to prevent vibration that causes squeaking. --brake pads with external shims (usually thin sheets of metal) between the pad and the rotor. --lubricant OR adhesive between the brake pads and the caliper to prevent vibration. Auto manufacturers specify what anti-squeak measure(s) should be used for brakes of specific vehicles. If whoever installed your brakes didn't follow the correct recommendation, that could be why they squeak. It's also possible, but less likely, that the wrong pads were used. You should take it back to the shop that did the work and ask them to do it correctly.
I have had bikes with disk and regular brake pads. Disk brakes dont squeak like regular brake pads and stop you much shorter. This is why disk brakes are more expensive.
Every time it becomes defective.
most of the time its in the trunk on the side ....
The brake pads have a small metal piece which makes he brake squeak. This means it's time to change your brakes. The longer you let it squeak, the more damage it does to you rotor. Still the rotor can be resurfaced or if needed replaced.