This is a response to a similar or perhaps related question - might be helpful : "I own a 1997 Ford Taurus and the same thing happened to me. The best answer that I received so far is that the module just went capoot (shorted, burned out, whatever). The default status for the module is "Steady On, High Beam". The quoted cost for the replacement part for me was $166.93 and the part had to be ordered. Not wanting to invest that amount of money yet, I pulled out the fuse (located under the hood) during the day and plugged it back in at night. I later found that I could leave the fuse out and just turn on my high beam when I drive at night (result is the same being that the default is "High Beam"). (I have to be inconsiderate for my short 2 mile drive and it's not every night). There are some postings out there explaining how to bypass the module. It appears that in some places it is illegal to do so. There is an increasing amount of consumers that see this module as an unnecessary expense forced on us. I don't know if you were expecting a technical answer to your question or not. Capoot is as technical as I can get. Good Luck!
most likely bad switch
you need to replace the fuse for the headlights.
Blinking is the way of protecting the lens from dust and other poisonous materials.
first make sure hazard lights are not on.next you need to ckeck the grounds from the battery.
Animals keep snow out of there eyes by blinking :)
When it is raining during the day you should always keep your headlights on.
i too have same problem. i noticed that when i turn on head lamp then only red LED keeps blinking.
Just pull the parking brake up one click. It won't engage the brake, but it bypasses the headlights.
yes
by blinking and sleeping, basically closing your eyes
It means the security system is armed.
rewire them.