0
Why do you have to put a hand over the carb to get it to start when it's cold Runs great when it warms up Carb. just rebulit new intake valve?
Wiki User
∙ 10y ago
You have to put a hand over the carb to get it to start up when it is cold because the air to fuel ratio is better when there is warmer air. To avoid this, try to use more choke when it is colder out.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What valve is exhaust and what valve is intake?
intake valve is bigger.
Where is the cold start valve on a 1989 740 GLE?
underneath the intake between the block and lower intake mount
Which valve is intake and which is exhaust?
An intake valve is larger.
What valve is exhaust and what valve is intake on 96 GM 350Ci?
The bigger valve is the intake.
How does a fire start in a carburetor?
Normally from an engine backfire. The plug fires when the intake valve is partially open which will explode the fuel in the intake and carb.
What valve is exhaust and what valve is intake on 16HP vanguard Briggs?
The intake valve is always the larger of the two.
How do you tell Which is the intake and which is the exhaust valve on a 305 motor?
The intake valve is bigger.
Why the clearance of gap exhaust valve is big than intake valve?
The exhaust valve gets hotter than the intake valve.
Where is pcv valve for mercury villeger 96?
The PCV valve is located on the back side of the intake plenum.. When facing the engine, locate the second intake from your right. Run your hand to the back side of the intake plenum. The PCV valve is screwed into the backside. Start the engine, disconnect the hose from the valve. You should hear the air from the valve. Stick your finger on the hole and you should feel the vacuum on a good valve. If not, replace it.
In most engines head of the intake valve is?
the intake valve head is larger than the exhaust valve head
How do you tell difference between exhaust valve and intake valve on 1998 suburban 5.7?
The intake valve is bigger.
Why the intake valve smaller than exhaust valve?
The intake valve is always larger than the exhaust valve. It's just physics.
