Window motor getting tired?
you need to replace the window master switch
How to repair power window in 2000 Ford Ranger passenger window will not work with either drivers button or passenger button the relay does not make any clicking noise either What is wrong?
PRESS THE BUTTON DOWNHOW DID YOU GET A DRIVERS LICENSE
Check if there is voltage to window regulator motor; if there is replace motor.
have you checked to be sure that the driver lock out button has not been pushed. it is usually above the window controls and it use to keep small children from rolling down the windows.
If you mean the extra switch on the drivers side power window control it cuts power to the passenger side window switch. Handy if you have kids.
it could be the window regulator
You will need to raise the drivers side window all the way up and then hold the button in the up position for about 20 seconds, that should do it.
Press and hold the button to put the window the whole way down. Release then hold down for 5 seconds. Pull and hold the button to bring the window the whole way up. Release then pull up for 5 seconds. Your windows should now be reset and can be controlled from the drivers window controls.
The window lock is faulty. It happened on my Jeep and i replaced the driver's dorr control module and it worked just fine...until that one broke too.
Theres a button on the drivers door, not on the section with window switchs below that near the bottom of the door
I felt dumb but I had the same problem, there was a WINDOW LOCK I had pushed, it is on the Drivers Door. My youngest son figured it out