Top Answer
User Avatar
Wiki User
Answered 2013-02-14 00:45:48

Replace the coolant temp sensor next to the thermostat housing.

User Avatar

Your Answer

Related Questions

The ECM on a 1992 S10 Blazer is located below the glove box.

Chicago Flood happened in 1992.

No. A Chevy Blazer does not have a reset switch.

Put your new fan belt around the pulleys of your 1992 Chevy Blazer. Tighten the fan belt with the tensioner pulley.

yes, most of the parts are interchangeable from the blazer to the pick up.

Formed in 1989, but the first album was in 1992.

like any 2 stroke chainsaws weed eaters merc outboards motor mowers ,motor bikes check fuel prime don;t flood first pop choke in.

I live in DE and they wanted 12 to 15 hundred to do my 1992 blazer.

It would bolt in but you would have fuel injection problems.

you most likely need to change them

The starter solenoid is attached to the starter.

No. The 2001 TrailBlazer was simply a trim package for the Blazer, which used an electronically controlled 4L60E transmission. The 1992 pickup would have a mechanical 4L60 transmission.

The fuel pump relay on that 92 Blazer with the 4.3 engine is located under the hood, on the firewall, drivers side, if there is more than one relay there, it's the one closest to the drivers fender.

i had the same problem with my 91 blazer turned out it was a combination between bad battery terminals and leaky vacuum hoses so check thoughs and replace if necessary

In the gas tank. You have to remove the tank to access it.

Under the Dashboard on the Drivers side, has a Plastic Cover.

low pressure on you MAP sensor clean it or replace it

They have an internal voltage regulator. i.e. it's in the alternator.

he started in 1992 first pick overall

The answer to this depends on exactly what you are going to repair.

Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.