answersLogoWhite

0


Best Answer

The blower is behind the glove box. Loose connection where the wire attaches or bad motor. You should be able to see the blower motor by looking up behind the glove box. Depending on the type of vehicle, it is either directly up or forward on the firewall.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does blower motor only turn on when hitting glove box?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the location of the blower motor on a 2000 vw passat?

Behind the glove box on the passenger side. It's only 4 screws to remove the glove box and then 3 to remove the blower motor


2000 sentra blower only works on high?

You need to replace the blower motor resistor located near the glove box.


Grand prix blower motor only works on 5 setting what is wrong?

It is the blower motor resister that shorted open. it is retangular in shape and is usually by the blower motor behind the glove box. It have two or sometimes 3 bolts holding in it.


Why your ac fan blower work only on high position?

replace your blower motor resistor it is behind the glove box two 8mm bolts


Where is blower motor for the heater on a 2001 Chevrolet Impala?

If your wondering because you only get a 2 or 3 selection for blower instead of 5. and your replacing blower resistor, im told go behind glove box? never tried it. The blower motor is directly above the glove box. Directly in front of that is the resistor for your ac/heat.


Chrysler town and country blower motor works only in high speed?

The most likely problem is the blower resistor located behind the glove box door.


If the heater fan only works on speed 5 in a 2001 silverado what is the problem?

Sounds like the blower motor resistor. Should be near the blower motor under right side below glove box!


How do you replace the blower motor resistor?

I do not know what vehicle you are referring to but I just replaced one on a 1996 Nissan Sentra because the only speed that was working on the blower motor was 'high'. Underneath the glove box was a couple of screws that came out and the new resistor was put in. Two screws and done......... Most blower motor resistors are located close to the blower motor.


Blower motor only runs on high?

Bad resistor at the blower motor? Bad blower motor switch?


Where is the blower motor located on a 1996 Nissan Maxima How do you replace it?

the blower is behind your glove box. You need to remove the glove box to get to it. this is what your looking but it will be upside-down. Its only a couple screws, and a plug to connect. I went to a junk yard and found one to but on my 95 max.


Why does my 2005 jeep liberty blower motor only work on high?

The most common cause of the blower only working in high is the blower motor resistor…. I don't recall exactly where it is on a liberty but it should be somewhere behind or underneath the glove box…. It adds resistance to lessen the speed of the motor until you put it on the high setting then it gets straight battery voltage…. I hope this helps you out


How to Replace blower motor resistor on a 2001 Ford Focus SE?

The blower motor resistor in the us models of the Ford Focus is behind the glove box, against the firewall, to the left of the actual blower motor.....my stock one was blue. it is only held in by one screw....just unscrew it and pull it out. They are like 15 dollars from the dealer.