0
Why does car start but park lights don't flash when pressing the remote on remote car starter?
Wiki User
∙ 14y ago
check if your lights are still on that drained the battery
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why will everything on a 2006 cadillac remote work except the starter batteries ok because everything on both remotes work only lites flash no starter?
Because the flash drive memory they installed on the remote is full
Why does a 1989 Ford Aerostar parking lights stay on after shutting off the headlights even when vehicle is shut off and will remain on until battery is dead?
I would suspect a bad headlight and / or turnsignal switch assembly. I just ran across this problem recently with an 89 Aerostar with an Astrostart remote starter. When using the remote to lock the vehicle, the parking lights flash on and off. Something with the Astrostart was keeping the parking lights on until I shut the power off to the remote starter and from that point on the parking lights shut off fine. I don't know though what in the Astrostart is causing it. I don't know anything about remote starters. The owner is happy that his battery no longer goes dead but now he has to get help with the remote starter.
What remote systems are available for Nikon cameras?
The Nikon Remote Wireless Flash System Is Easy To Use www.scantips.com/lights/awl.htmlThe idea is this: Using the Nikon Commander/Remote system, set the camera internal flash menu to Commander, and set each remote flash to Remote mode. ... How to trigger speedlights Off camera www.scantips.com/lights/trigger.htmlMethods to Trigger the Speedlight Off Camera. ... Nikon Commander/Remote Wireless Remote System ... However, there are a few little details. Remote flashes ...
Why will Everything work with remote except remote starter lights flash but no start both remotes?
If the lights on the dash all light up but does not crank, this is probably the immobilizer system killing the starter. This is only with cars with a chip in the key and when they put the remote starter in they used a 556u peice and probably took one of your chip keys and installed it in the car. When they wrapped the windings around your key cylinder to "trick the car to thinking the key is being used" they may not have secured it properly. If this car doesn't have a chip key then I'd check to make sure the starter wire (Starter side) is hooked up. On directed electronics products its usually a thick purple wire
How do you use the remote start on my Cadillac SRX?
i found this online today but have not tried yet. you have to lock the doors with the remote and then press and hold the half arrow circle button on the remote until the lights flash.
How do you program a remote for 2000 Nissan Pulsar?
If it's a N15 then you put the key in the ignition and switch it to "ON" and then "OFF" five times, or until the indicators flash. Then press the button on the remote. The lights should flash when it registers the remote. If you have more than one remote, just press the next button and it should register it as well.
How do you use the remote start on my 2011 CADILLAC srx?
i found this online today but have not tried yet. you have to lock the doors with the remote and then press and hold the half arrow circle button on the remote until the lights flash.
My xterra remote is in silence mode and when unlocking doors the lights dont flash?
How to change hazard and horn reminder modeWhen LOCK and UNLOCK signals are sent from the remote controller for more than 2 seconds at the same time pressing both buttons, the hazard and horn reminder mode is changed and hazard warning lamp flashes and horn sounds.
How do you reset Hyundai coupe remote handset re-synchronisation?
Put key in the ignition and turn it to ACC position and then either press lock or unlock button on your remote, the hazard lights will flash twice. This will reset the remote.
Keyless remote on n15 Nissan Pulsar help?
Get into car and close the doorsInsert key and turn ignition from off to ACC and back off five timesOn fifth turn, the hazard lights will flash onceTurn ignition OFFPress button on the remote controlHazard lights will flashRemove the key and test that the remote locks
How do you get the horn to blow and the parking lights to flash when you hit the lock button on your remote for your KIA Optima Manufactuer Car Alarm?
Ask a car professional
On a 2002 Hyundai How do you make the alarm chirp instead of being silent I have a factory alarm and I have no idea how it works Someone help me?
Generally, you press the remote button once and the alarm arms and the lights flash once. If you press it a second time, the lights flash again and the alarm chirps.
