answersLogoWhite

0


Best Answer

it may need to be adjusten on the fuel/air or the float s if carburated need to be adjusted

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does it idle fine then when you want to go it hesitates?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1988 astro runs and drives fine when cold after warms up hesitates and putts unless you go past 14 throttle?

Connect it to a code scanner, see what the computer says.


How do you be sure if she likes you or not?

Try just talking to her and building a good, strong friendship. Eventually, if you like her, ask her to go to a movie or something. If she says yes, then she likes you, if she hesitates, he doesn't want to be mean, and no, well, then she doesn't want to go.


Why is it the Car runs fine during idle after a few cranks then once you push gas to about 2500 3000 rpm it bogs down once you put it into gear it doesn't want to go anywhere and wont go over 10?

Check the fuel pump and fuel filter.


What causes my 87 bronco ii to surge at idle then diewhen i restart it will go to high idle then the idle will slowly reduce down to 800 rpm and idle fine it only does this when it's a cold start?

on the left side of the intake is a round cylinder with wires plugged into it. this is the idle control. It is most likely dirty. take it off and clean it out with carb and choke cleaner.


Why does your 1977 Suzuki spirit 25hp outboard motor idle fine and revs fine and you can put it in gear and troll but when you try to go fast the motor dogs and stalls any ideas?

carburator jets clogged!


Why does my 2003 Chevy Suburban hesitates during acceleration?

it hesitates because its governed and it wont let you go over 100 mph so when your accelerating it starts to hesitate around 70 to 80 mph you cant go over 100 mph


What could cause p1000 code rough idle on 2001 Ford Ranger 4.0L Truck runs fine above idle but stalls at idle?

P1000 on any ford means you have cleared the PCM codes and it hasn't run it's self-diagnostic tests yet. This will go away. It is not related to your rough idle.


Why does your 1998 F-150 start and idle fine and accelerate fine but when put into gear it wants to stall and sputters?

You idle air control valve is having a problem as well as carbon build up in the engine. Part store chemicals won't event make a dent in the carbon. Go to your Ford dealer. It will cost about $500.


What is wrong with my 2003 silverado it idles rough and will go dead when put in gear?

its most likely your idle control sensor. if you replace it the truck should run fine.


Why would a 1994 Mercury Topaz idle low but run fine until you go up a hill when it loses power and also stall in traffic?

Check fuel pressure.


What would cause a 1996 F-150 to idle fine but bog down when you apply the gas?

Auto Zone will read your computer codes for FREE.. Have your codes read and go from there.


Do you have to attend college in order to be an actor?

no not if your still young if you want to go to college that's fine but no you do not have to go to college