0
Why does my 93 ranger 2.3L Idle fine but bogs out when you step on gas pedal?
Wiki User
∙ 14y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Cr125 2002 it bogs down at high rpm it run fine but when you let it idle down and then give it gas it bogs down it runs fine with the choke on took carb off took it apart cleaned it reeds a?
check the jetting.
Why does a 95 ranger with a 23L idle at 2 or 3k rpms and sometimes idle fine but starts fine sometimes but floods other times?
You might want to chech your idle air bypass valve it is located next to the throttle posision sensor. They uild up with carbon and do not want to work properly
Why would a suzuki Samurai idle fast and run hot. The head was just changed. It runs fine but it bogs down when loaded until the rpm gets up?
I would be looking for a vacuum leak.
What are the symptoms of a faulty idle air control valve?
A faulty IAC will cause stalling problems at idle. Most of the time if you hold the gas pedal down it will run fine. Be careful because these symptoms can come from an EGR valve that is stuck open aswell. If you have a fast idle i would look for a intake leak.
What if your truck stops runnung after about 65miles an hour but let off the pedal and it idles fine give it gas and it dies?
OK, at around 12miles down the road at about 65 miles an hour my truck losses power when i let off the gas pedal it seems to idle fine turn the ignition off wait for 3-5 min turn key and continue. OK, at around 12miles down the road at about 65 miles an hour my truck losses power when i let off the gas pedal it seems to idle fine turn the ignition off wait for 3-5 min turn key and continue.
What could cause p1000 code rough idle on 2001 Ford Ranger 4.0L Truck runs fine above idle but stalls at idle?
P1000 on any ford means you have cleared the PCM codes and it hasn't run it's self-diagnostic tests yet. This will go away. It is not related to your rough idle.
Is a broken or disconnected accelerator cable a likely cause of accelerator suddenly not working but engine is running fine?
Yes, a broken or disconnected accelerator cable is the likely cause for the accelerator pedal to quit working. The car will still run fine but will not be able to accelerate past idle.
Why is it the Car runs fine during idle after a few cranks then once you push gas to about 2500 3000 rpm it bogs down once you put it into gear it doesn't want to go anywhere and wont go over 10?
Check the fuel pump and fuel filter.
Why would a 1999 Ford Expedition idle too low in foggy weather but run fine when warmed up and idle fine in dry weather?
Idle Air control (IAC) Bad Idle Air control (IAC) Bad
Why would a GM 3.1 liter engine idle smooth and rev up strong but sputter a stall when put into gear?
...sounds like you've got a dirty fuel filter. Fuel is delivered fine at idle, but when higher demand is made ( you press down gas pedal, the blockage prevents delivery of fuel.
When in park vehicle has high idle and shakes but when are moving it is fine?
Let it idle when moving and get back to us.
I have a 2000 Chrysler Town and Country Lx 3 3 the idle is very rough when stop while in drive or reverse once pedal is pressed engine runs fine just changed the fuel filter and cleaned throttle body?
The IAC (idle air control) may be at fault. Has the check engine light been on?
