0
If your car is a Diesel engine and when you turn the key on it ignites the glow plugs because diesel gas can congeal (become thick) in cold weather. So the glow plugs warm the diesel and turn it back to a more liquid state.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why do people wait 30 min before going into the water?
they have to wait 30 min before they go in the water because you can get a very bad cramp
Why do you have to wait 30 min before you go swimming?
You do not have to. This is an urban myth. You don't have to wait 30 minuted before swimming.
How long should you wait to report an injury after a car accident?
0 min.
Why would your car start and then run for approx 5 min then die and not start back up?
Depends on the car....what is it???
93 Lesabre will start most of the time like a new car but once a day it will not start It turns over but seems like it not getting any fuel If you wait 10 min it will start like a new car again?
your fuel pump is going out. there might be a check valve in the pump that is becoming faulty.
1993 ford E350 runs fine but if you shut off engine for 3 min it will not start but if you wait 10 min it will start what will cause this?
If it has a Diesel it is probably the injector pump starting to fail.
How do you reset key immobilizer 1995 camaro z28?
I just purchased the 93 ver. of this same car with the same prob. The mechanic saidto turn the key to "on" (not start!) and leave it for 10 min. After that doesn't work you can disconnect the battery and wait a minimum of 30 min. Put the key in then re-connect the battery. My car started for a mere min before cutting out again. These dang security measures are more trouble than they are worth. I Wish they could just be Removed completely!
What would cause my 91 beretta to run perfect then just die and when you start it just turns over perfect just wont go into drive so you wait about 10 mins and it runs perfect again?
nottin that any mechanic could solve so i suggest to simply just get a new car dah or you'll just have to wait 10 min. to start your car
How do you reset passlock on 1999 gand am?
For the Passlock 2 system, put the key in the ignition and turn the engine over (the car should not start, if it did you are done), turn the key to the ON position, let it set for 10 min. The security light should be flashing. After 10 min. the security light should stop flashing the car is ready to learn the new key value. Turn the key off, wait 5 seconds, and then try to start the car.
How do you reset tcm?
remove it clean pins and replace them if needed turn car in on position wait 5 min reinstall.
How long can you wait before you put your ipod on a warm surface?
you should wait 3-4 min. before you put it on a warm surface if you dont wait that long atleast, you will fry the battery and it might shorten life span of ipod.
How do you reprogram the ignition key for a 2002 Cavalier I changed the ignition and I can't start it.?
you have to tow the car to the dealer they use a special tool to flash the computer its not a home job dealer olny Answer Try this: Put the key in the ignition, try to start the car (the car won't start), release the key and leave the key in the ON position for 10 min. during this time the security light on the dash should be flashing. After 10 min. the security light will stop flashing and shut off. Turn the key to the off position, wait 5 seconds or more, now start the vehicle.
