Could be many reasons. The year, make, model and engine info would be helpful. If the check engine light is on have it scanned for codes. This would be a good place to start.
car turn off when put in to drive i hit the gas an it starts shacking an turns off why?
No but, be sure it has come to a complete stop before you put it in park.
put the car in drive and crankshaft wont turn anymore. then you can take off the bolt
You may have left the car in drive
well you can do you turn the car off after or do you just do it at stop lights? If you put it in neutral at stop lights and signes and then put in gear to drive it add wear to your transmision. Just leave it in drive when driveing.
you should put your car in neutral when it has come to a complete stop, or when you turn it off or on
Shut it off in drive, then put it in park.
No.
it doesn't to me
Check your power steering fliud, if it is low this could cause the vibration you are feeling.
You first put the car into either neutral or park (this will depend on whether the car is an automatic or stick (manual)), and then you start the car again. That's it! Good luck.
1. Turn on your right turn signal 2. Get about six inches from the curb 3. Turn the steering wheel all the way to the right 4. Put the car in neutral and let the wheels roll until the hit the curb 5. Put the car in park 6. Put on the emergency brake 7. When you are ready to leave, take off the emergency brake, put the car in reverse, and gently get off the curb. Then put your left signal on, put the car in drive, and leave. An easy way to remember if you turn the wheels left or right is: Up up and away. If you're uphill parking turn the wheels away from the curb. Down Down in. If you're downhill parking turn the wheels inwards towards the curb.