0
Why does steam come out of the tailpipe of a 2005 Mazda RX8 1.3 Rotary motor it has no head gaskets?
Wiki User
∙ 14y ago
Steam? RX8 normally smokes from the rich fuel mixture. When you turn the car off, especially when it is cold, it steams.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
When was the Rotary motor of Mazda launched?
The Rotary motor of Mazda was launched for the first time in 1967. It was invented by a German man named Felix Wankel. One can find more details on the Mazda website.
First car company to get 100 horsepower per liter?
maybe Mazda with the rotary motor?
If an engine on 95 Lincoln Continental stalls and blows thick white smoke out tailpipe is it time to replace engine?
check the head gaskets before you replace motor
Is a 1999 Mazda protege 1.6L a rotary engine?
No. It is, however, a reciprocating 4 cylinder, water-cooled 4-cycle (Otto cycle - spark ignition) piston motor. From the 1980's, the Mazda rotary (nee Wankel) engine has only been available in the RX- series (RX : Rotary Experimental). There currently exists a JDM rotary engine hybrid Mazda5 model, leased in very small numbers for research purposes.
A rotary converter can be run as?
Induction motor
Where can you buy a used or rebuilt Mazda wankel rotary 12-A-engine?
There a bit old now a days and Mazda stopped making housings for them. Any wrecker should have one laying around. Check for compresson but l'd factor in the price of a rebuild when buying the motor.
Where are Mazda factories in Europe?
There are a number of Mazda factories found in the continent of Europe. These include Mazda Suisse, Mazda Austria, Mazda Motor Italia, as well as Mazda Motor Europe.
Where is the motor mount on a Mazda MPV?
how many motor mount has a mazda mpv 2000
How do i Remove the starter motor Mazda rx8?
how do i remove the starter motor Mazda rx8
If the rotary motor had a head gasket what would it be?
It would be the gaskets between the front middle and rear housings. the "block" is made up of 5 sections put together front middle and rear sections are cast iron and the two rotor housings are aluminium.
What is the actual name for the spinning attachment on a rotary motor?
Rotor
Is it better to repair head gaskets or replace the engine?
if the miles on the engine aren't too high, then just replace the head gaskets. if the whole engine is tired go ahead and swap out the motor. its a lot cheaper to do the gaskets then to buy a new motor.
