There are a couple of reasons this could occur.One could be that the temperature sender is defective and needs to replaced this is what makes the gauge on the dash show a reading.Two is if the temp sender is not defective then it could be a faulty gauge meaning the gauge needs to be replaced.Also a short in the wiring or bad connection can cause this.As long as you have normal heat temps when in the vehicle I would not think it is ur thermostat being bad.The only thing that may cause the needle to not be in the normal position is extreme cold but the gauge should show a reading.If the gauge does not move at all, I say it's more than likely the temp sender is bad in most cases.I would not rule out other issues but,most typical is the sending unit,and not the gauge or short or bad connection.I could elaborate on checking lots more but,this is alot to begin with.
Check your antifreeze level.
The motion of the needle in a sewing machine is vertically, rapidly up and down.
cause
You cannot chop a tree down with a knitting needle as the needle does not have a sharp edge. You could bore it down if you lived long enough.
1) What goes up, must come down. 2) What goes down, stays down. 3) What stays down is probably dead.
Mine stays at the first quarter, up from cold. I would add more coolant if the gauge is unstably going up and down at different speed. I think you may have a slow to open or sticky thermostat if you feel nervous as your engine warms up, and the temperature needle climbs and climbs, and starts to smell like roast duck with penzoil au jus...
The needle clamp is collar and screw device that holds the needle to the needle bar. The needle bar is the part that goes up and down as the machine sews and is in front of the pressed foot bar.
the oven indicator light stays on and the temperature light but i turn the oven nob on and the oven heat up then i turn off . it gos out tell the temperature cools down. then it come back 0n.
Automatic declutch bobbin winder – which means the machine automatically stops the needle from going up and down when you are winding thread onto the bobbin. ... Needle up/down button – this button allows you to start and stop with the needle in the down position if it is highlighted.
This happens because the mass of the rod stays the same, but its volume increases. The increase in the volume of matter withincreasing temperature is called expansion. When cooled down, mostmatter decreases in volume and increases in density.
The needle bar is a component of a sewing machine that holds the needle in place and controls its up and down movement. It is connected to the machine's mechanism that creates the stitch by moving the needle in synchronization with the fabric being sewn.
lower down