0
Why does the blower fan only work on 3 or 4 in a Chrysler Sebring?
Wiki User
∙ 10y ago
The usual cause is a failed blower motor resistor.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Why does your fan only work on high in a 2006 Chrysler Sebring?
blower motor resistor
Why does the blower fan only work on high in a 2006 Chrysler Sebring?
blower motor resistor needs to be replaced
Why does the ac fan in your 2004 Chrysler sebring only work on high?
The blower motor resistor has failed.The blower motor resistor has failed.
Why does the Fan motor for Chrysler Sebring not work in lows speeds only 4?
The common cause is a failed blower resistor.
Why does the heater fan only work on the high position on a 2001 Chrysler Sebring?
The most common cause is a failed blower motor resistor.
Why would the air only work on speed 4 in my 2004 Chrysler Sebring?
The blower resistor has failed. It is located at the very bottom of the passenger side of the dash.
Chrysler sebring ignition damage by thief key doesn't work how do you replace?
Chrysler sebring ignition damage by thief key doesn't work how do you replace?"
What causes the blower motor to work on high only in a 2001 Chrysler Town and Country?
Usually the blower motor resister has gone bad.
Where is the blower resistor pack on a 2004 Chrysler sebring touring sedan?
On my 2002 it is mounted in the blower housing that is on the front passenger side above where the foot area is, may have to remove a panel to see it, some wires are plugged into it and two screws hold it in place. When mine failed only the hi speed setting would work.
What is wrong when the hazard and turn signals don't come on in a 2002 Chrysler sebring convertible?
turn signals won't work. changed all the bulbs. Hazard lights work. 1999 Chrysler Sebring hardtop
What engine would work in a 2004 Chrysler Sebring convertible?
The same size that was in there is what will work with out major modifications.
Why does your air conditioner switch only work on high in your Chrysler voyager van?
If you mean the blower only goes in the high mode check the blower resistor located in the plenum under the wiper module.
