0
Where is the blower resistor pack on a 2004 Chrysler sebring touring sedan?
Wiki User
∙ 13y ago
On my 2002 it is mounted in the blower housing that is on the front passenger side above where the foot area is, may have to remove a panel to see it, some wires are plugged into it and two screws hold it in place. When mine failed only the hi speed setting would work.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What is the problem when the fan speed only works on high for a 2008 chrysler sebring?
The blower resistor has failed.The blower resistor has failed.
Why does the ac fan in your 2004 Chrysler sebring only work on high?
The blower motor resistor has failed.The blower motor resistor has failed.
Where is the blower motor resistor on a 2005 Chrysler Sebring?
It is under the dash on the passenger side.
Why does your fan only work on high in a 2006 Chrysler Sebring?
blower motor resistor
Why does the blower fan only work on high in a 2006 Chrysler Sebring?
blower motor resistor needs to be replaced
Why does the blower fan only work on 3 or 4 in a Chrysler Sebring?
The usual cause is a failed blower motor resistor.
Where is the blower motor resistor on a 2005 Chrysler Town and Country Touring?
It is behind the glove box.
2003 Chrysler Sebring where is blower motor resistor located?
under the dash. if you can find the blower motor then it should be right above that
Why is the blower motor not working on a Chrysler Sebring?
The blower resistor is probably bad, due to a failing blower motor that is drawing too many amps.
Why does a heater fan resistor keep burning out on a 2004 Chrysler Sebring convertible?
The blower motor is failing and will need replaced.
Why does the Fan motor for Chrysler Sebring not work in lows speeds only 4?
The common cause is a failed blower resistor.
Where is the blower motor resistor on a 1998 Chrysler Sebring?
Fig 15 Blower Motor ResistorNOTE: The blower motor resistor is located on the lower right side of the heater housing.REMOVAL# Remove lower right underpanel silencer/duct. # Disconnect wiring connectors on blower motor resistor. # Remove blower motor resistor retaining screws. # Pull blower motor resistor out of heater housing.
