The computer turns on the check engine light in hopes that you'll check the engine codes. It means something is wrong. Use an engine diagnostic scanner to find out what it is. It's easy to do and you can usually borrow one from your local auto parts retailer, they'll often help you figure out what it all means.
To reset the check engine light on a 1999 Oldsmobile Silhouette, you can disconnect the negative battery terminal for about 15 minutes. This will clear the vehicle’s computer memory, including the check engine light. Alternatively, you can use an OBD-II scanner to erase the trouble codes that triggered the light. However, it's essential to address any underlying issues before resetting the light to avoid recurring problems.
First, the oil change has nothing to do with the check engine light. The EGR may have not been the problem. You need to have the codes read and diagnose from there.
That is the check engine light.That is the check engine light.
No, oil level does not cause the check engine light.
The service engine light is the same thing as a check engine light.
The check engine light is the light shaped like an engine, or the light that states Check Engine (Soon). If this light comes on, it is time to see what the issue is with the engine.
engine light is on 1997 olds sillouette tranny slpis code
Yes, the Service Engine Soon light is the same as the Check Engine light.
There are sensors all over the engine that can turn the check engine light on.There are sensors all over the engine that can turn the check engine light on.
The check engine light does not generally have anything to do with the check oil light. The oil light just indicated it is time to change the oil, while the engine light indicates a problem.
That indicates the engine temp is running to low: the computer should give a check engine light and often the temp gauge will not work either. you need to replace the thermostat
To reset the change engine oil light in a 2003 Oldsmobile Silhouette, first turn the ignition key to the "On" position without starting the engine. Press the gas pedal three times within five seconds. After this, turn the ignition off, and then start the vehicle to ensure the light has reset. If the light remains on, repeat the process.