Maybe need a new computer?, check to make sure it is receiving 5 volts to the sensor.
Code P0113 indicates a intake air temperature sensor circuit high output. Check the connection to the intake air temperature sensor and if that is fine consider replacing the intake air temperature sensor.
an intake air temperature sensor is a sensor that is used to measure the temperature of the air that flows through your intake manifold into your engine.it is usually posisioned on the intake filter housing.
it is in the intake manifold by the throttle body and the map sensor. it is a two wire sensor
It's located on the intake manifold itself.
The IAT Sensor on a 1992 Geo Tracker is the Intake Air Temperature Sensor. Replacing the air filter might fix this problem.
The intake air temperature sensor can be found on the top of the air intake manifold. The temperature sensor should be labeled as such.
The IAT (Intake Air Temperature) Sensor is a Two (2) Wire sensor located close to the intake.
The air intake temperature sensor can be found on the top of your manifold intake. The sensor will be right in the middle of the intake manifold.
Trouble code P0113 means: Intake Air Temperature Sensor 1 Circuit High Input Try replacing the IAT sensor
The intake air temperature sensor is located on top of the intake. In a 1990 Toyota Camry the air temp sensor assures the ECU the engine is running at optimal temperature.
A 1998 Jeep Cherokee does not have a mass airflow sensor. It uses a manifold pressure sensor, MAP, which is on the rear of the intake manifold.
It should in the air filter box or if you have a MAF sensor, the intake air temperature sensor is a part of the MAF.