Chevy Silverado
Buick LeSabre
Oldsmobile Eighty-Eight

Why does the converter lock in and out on a 97 Buick LeSabre?

171819

Top Answer
User Avatar
Wiki User
Answered
2007-10-16 01:30:27
2007-10-16 01:30:27

Many reasons all computer controlled

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


97 lesabre buick gas meter doesn't work can we fix it?

where is coolant sensor on a 97 buick lasbre

Most likely not. Buick changed the front end design on the LeSabre in 1997. They are probably a completely different hood.

The horn relay on a 97 Buick LeSabre is located at the front of the engine compartment, near the headlights. It provides power to the horn and triggers it when the button is pressed on the steering wheel.

4.5 quarts with new oil filter

Manifold Absolute Pressure/Barometric Pressure Sensor

I had to use an Allen wrench, it wasnt a socket however my lesabre is a 93

97 buick lesabre center front wheel bolt size

Check fluid level, are there any noises, what are the conditions when problem occurs?

Remove the positive cable from your 1997 Buick LeSabre battery. Remove the alternator belt. Remove the alternator wiring harness. Remove the alternator retaining bolts. Reverse the process to install the new alternator.

The 1997 Buick LeSabre intake manifold bolt torque specifications is 45 pounds per square inch. The manifold bolts should be torqued in 15 pound intervals.

If you can't find drain plug, just disconnect lower radiator hose.

Small pedal on the left of the brake pedal - activates the rear brake to hold vehicle

10W30 and always make sure it has the round "For gasoline engines" seal on the front.

Don't put a buick engine in a camaro. Instead, get a 350 LT1 (GM - corvette engine) for about 200 bucks used or 800 new. Sell the lesabre for this engine if you need to.

It would be wise to replace the wires one at a time so not to mess up the firing order.

Cheap gas, try putting the highest octane, believe me it will make a difference.

Hi , hope you can help me. Can you tell me where the oxygen sensor and the EGR valve are located on my 1997 Buick LaSabre. Thanks

There might be a picture of this under the hood. Alot of GM's have this. It is possible that the engine mount will have to be removed for this depending on what engine you have .

I have a 95, had a misfire... mine was because of the plug wires... changed the wires and plugs mis fire stopped...

I'm not sure exactly what your asking, but the entire chasis of the vehicle is considered 'grounded', because of the ground connection at the battery.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.