0
If the tip is getting damaged, there is a loose or broken part inside the bell housing. If the wires are getting chewed on, you have a rodent problem.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Where is a crank sensor on 2000 dodge 2500 5.9?
in the distribuator
Where is the crank shaft sensor on the 2000 dodge intreped?
It's on the passenger side of the bellhousing.
How do you remove crank sensor on a 2000 Dodge Intrepid?
Disconnect the electrical connector, remove the mounting screw and remove the sensor.
Where is the crank shaft sensor on a 2000 Dodge Cummins Diesel?
It is in the side of the block behind the starter.
The crank sensor on your 2000 dodge neon keeps failing any suggestions?
crank sensor in 2000 dodge neon fails. car starts to stall while operating. idols with no problem, when in operation starts to stall again and again until will not start again.
How do you test a crank position sensor on a 2000 Dodge Intrepid?
scanning for codes will indicate if the CPS is at fault.
Where is the crank sensor on a 2000 Nissan Sentra?
where is the crank sensor located on 2000 nissan sentra
Where is 2000 dodge ram standard 5.2 crank sensor?
It goes in the top of the bell housing, behind the passenger side head.
Where is the crank sensor on 2000 kia sportage 4x4?
crank sensor should always be near bottom crank pulley
How to replace mass airflow sensor 2000 dodge neon?
A 2000 Dodge Neon does not have a maf sensor.
Is crank sensor and knock sensor on 2000 villager same thing?
no, it is not.
Where is the oxygen sensor on a 2000 Cummins 5.9 Dodge diesel?
A 2000 Dodge Ram diesel does not have an oxygen sensor.
