0
Why does the front end of your 93 ford thuinderbird rattle when moved left to right but no noise when moved up or downcould the ball joints or tie rods be bad?
Wiki User
∙ 18y ago
power sterring leaking? might need to look at bushing needs replaced, not hard of job just look under front end not hard to notice trouble a allignment will tell you about problem 200 dollars to replace bushings
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
Why is there still a rattle in the front end of a 2005 Ford truck after the ball joints and tie rod ends?
possibly sway bar links,bushings, or maybe shocks
Why does my 1996 AWD outback rattle and click while turning and driving slowly cv joints are ok?
check your your front and back diff also check upper end of coil springs on front struts
How do you replace your front ball joints on Lincoln ls?
How do you replace your front ball joints on a Lincoln
Are their u joints on front wheel drive cars?
Normally there are constant velocity joints not u-joints.
Why does your 2001 convertible top rattle at the front?
bad header seal
2008 dodge charger front end rattle?
get the steering parts checked out along with the front struts.
What could cause a rattle in right front fender of my Toyota Camry?
A rattle in the right front fender of a Toyota Camry may indicate that you need a wheel alignment. It could also point to a problem with your struts.
Does an S10 need a lube job?
Yes drive shaft, front end searing and front ball joints (if rear wheel drive) front end ball joints for front wheel drive
How do you install CV joint on 2004 dodge ram 2500?
it has a solid front axle, therefore it has u joints, not cv joints found on independent front suspension(ifs) of GMs. CV joints are gonna be awful hard to install on a solid front end...
Why would your front disc brake pads rattle?
The attachment bolts might be loose
Your wife's 2002 Dodge Intrepid's front speakers rattle what to do?
They are either loose of busted.
How do you replace 2000 dodge ram 1500 front axle cv joint and boots?
The 2000 Ram had u joints, not cv joints at the front axle.
