Chevy Blazer
Ford E-150 Van
Ford F-150

Why does the fuel gauge not work on a 1997 Chevy Blazer?

181920

Top Answer
User Avatar
Wiki User
Answered
2007-03-27 02:53:10
2007-03-27 02:53:10

Bad sending unit in the fuel tank.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The fuel gauge fuse on 1998 Chevy blazer is located in the front of the blazer. It is on the driver side next to the hook latch.

The fuse box for the fuel gauge on 1998 Chevy blazer is located on the driver side. It is near the hook latch.

In the tank, it's called a fuel pump module.

My first guess would be the fuel pump is at fault.

this is incorrect. The fuel pump is located in the fuel tank. It is a lot of work to replace. I have done it twice on my 97 blazer. Its expensive too around 300 bucks. The fuel pump on a 1997 Chevey blazer is right beside the engine

It is located inside the fuel tank along with the fuel pump. The fuel tank must be dropped to gain access to it.

Where is the location of fuel pump relay on 1996 Chevy Blazer?

Need to check the fuel pressure with a gauge. May need a fuel filter too.

It is attached to the bank of fuel injectors (the spider) under the upper intake manifold.

The fuel pump may be fine but the sending unit may not be. The sending unit is probably the most common cause of fuel gauge failure.

I know that the 1 on the far left is the fuel relay

How do you wire a Pigtail for a Fuel Pump on a 97 Chevy Blazer Thank You EVa

The fuel gauge sensor is located in the fuel tank. The fuel gauge sensor and fuel pump are one assembly. To my knowledge they are sold as one unit and is fairly expensive. The fuel tank must be dropped to R&R the assembly.

If the fuel gauge isn't working on a 1999 Chevrolet Blazer it could possibly be because the float is stuck in the fuel tank. I had this problem when I got my 99 blazer, the float and sensor for the fuel gauge is on the fuel pump which is in the fuel tank to keep it temperature regulated. I had to replace my fuel pump, which ended up going bad on me, and after it was replaced the gauge works just fine.

probably no because Chevy changed the type of fuel injection and it probably operates at a different pressure.

more than likely its the fuel pump. common problem

No. A Chevy Blazer does not have a reset switch.

If the gas gauge is not reading there is possibly a short somewhere between the fuel tank and the gauge or the gauge itself is broken. I have found that in most cases the sending unit in the tank has failed.

When the fuel gauge begins to read empty, you probably have one to two gallons of fuel remaining which should get you 15 to 30 miles.

sticking float on the fuel pump, or malfunction in the float

If you have such a valve, it was installed as an aftermarket modification. Check with whoever installed it.

If you have spark at the spark plug, it is probably a bad fuel injector.

How do you replace fuel injectors on 2003 Chevy blazer?Read more: How_do_you_replace_fuel_injectors_on_2003_Chevy_blazer

which fuse is for the fuel pump in a 1993 chevy s10 blazer


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.