answersLogoWhite

0


Best Answer
Blower Fan Resistor ReplacementBehind and below the glove box is a "Blower Fan Motor resistor" which needs to be replaced. Motors are set to be either on or off (positions off and 4). A resistor varies the speed of the motor between off and full blast. When this is blown it needs to be replaced. Remove the glove box by pinching the top sides of the glove box inward towards the center and pull forward and down (make sure to remove all items in the glove box before or it'll end up on the floor). Pinch the sides of the resistor and pull out. I have found that most parts stores do not sell this item and it's only available through a dealer.
User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does the heater on a 2003 Chrysler Sebring only blow at the full setting?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where can you find the choke heat sensor on a 2003 Chrysler sebring 4-cylinder coupe?

A 2003 Chrysler Sebring is fuel injected and does not have a choke.


Does a 2003 Chrysler Sebring have a cabin filter?

No.No.


Where do you find 2003 Chrysler sebring lx owners manual?

The owners manual for a 2003 Chrysler Sebring LX is found at an automotive shop. It can be found and purchased from the dealership as well.


Do a 2003 Chrysler sebring lx have a oil filter?

yes


What grade of oil does a 2003 Chrysler Sebring need?

5w30


Does a 2003 Chrysler Sebring have a cabin air filter?

No, it does not.No, it does not.


Where is the cabin air filter in a 2003 Chrysler Sebring?

It doesn't have one.


Does a 2003 Chrysler Sebring have anti-siphoning gas tank?

Yes


Can you use r134a on a 2003 Chrysler Sebring convertible?

Yes, that is the proper refrigerant.


Is a 2003 chrysler Sebring convertible a zero tolerance engine?

Yes.Yes.


When should you replace the timing belt on a 2003 Chrysler Sebring?

100,000 miles


What is the oil capacity for a 2003 Chrysler sebring sedan 2.7L?

5 quarts