answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Why does the ktm 65 sx kick start lock up when you over tighten it?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you do a hard low kick?

1. Lean over the soccer ball 2. Strike through it, do not stop in the middle of your kick.--to master this, practice shooting and then touching your foot to your hand--3. Kick the center of the ball4. Lock your ankle


What would make a 1980 KZ750 kick start jam in neutral I removed stator cover and wrenched the crank it turns fine. Clutch in kick start cranks but not the engine. Was running great?

If i understand correctly when you have the clutch lever pulled in and try to kick start it the kick start spins freely. I also have that same issue it has to be in neutral with clutch let out then kick it over, maybe a safety thing


Where is the fuel pump located on a 1988 240DL Volvo?

Why does my car kick over but wont start?


Why does your car turn over but will not start?

for safety measures after any accident the innertia swish kick on


How do you start a ktm 65 in gear?

pull the clutch in and kick it over, or roll it down a hill


Can you put a kick starter on your Yamaha 1000 virago If so where can you get a kit to do this?

there is no provisions for a kick start and no normal human being could kick one over, Harleys had a totally different set-up that was made for kick starting.


How can you get your 1984 Honda cr 80r dirt bike to start if it wont kick over?

depends. can you push start it. need more info.


Why is my Yamaha blaster easy to kick but wont start?

probably dont have any compression. take spark plug out and put your thumb over the plug hole as you try to kick start it. if no air shoots out then its a compression problem


How do you adjust the idle in a 300SD 1984 Mercedes?

Its on the engine side of the injection pump. 14mm lock nut and flatblade screwdriver to adjust. Do not over tighten or you can break off the mount like on this pump. Turn the bolt clockwise (right) to increase idle speed, counter-clockwise (left) to decrease idle speed. Once adjusted, re-tighten the 14mm lock nut.


Where is the engine number located on an rm125?

Hi on my 1998 rm 125 its over the kick start ,under the exhaust pipe


2003 Pontiac grand am turns over and wont start?

security lock out had same problem with our 2004 grand am


How do you check transmission fluid 2005 Chevrolet Malibu 2.2?

under the car is a check plug it is located on the drivers side on the transmission i square head plug start car open plug fluid should flow out of plug do not do not over tighten plug do not over tighten