answersLogoWhite

0


Best Answer

Because it is not a good car!

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does the oil pressure sensor alarm on 1996 volkswagen jetta keep sounding after replacing oil pump oil sensor oil pan gasket and oil filter housing?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the 1998 Volkswagen passat 1.8 liter maf sensor located?

inside air filter housing


Replacing side mirror on Mercedes Benz c230?

The housing is broken not the actual mirror


Replacing Mercury villager speed sensor?

The speed sensor is at the top rear of the transmission housing.


Where is expansion valve on 1997 caravan?

Inside the hvac housing inside vehicle.requires removing dash and hvac housing to get at evaporator,and then replacing expansion valve!have fun.


S-10 blazer won't start without starting fluid?

Assuming it runs on its own once it is started, try replacing the coolant temp sensor, the one located next to the thermostat housing. The part should be less than $15. check fuel pressure must be at least 55 pounds of pressure I have fix few of these trucks and replacing fuel pump fix the problem also change the fuel filter these engines do not start with less than 55 pounds of pressure


Why is Oil running down below distributor case?

the O ring on the dist housing needs replacing


Can you repair a scratched Nintendo DS?

yes. you can buy a new Housing on Ebay.com or Amazon.com for around $15.00, Maybe less. Go to youtube.com to watch a video on replacing the housing.


How do you replace a brake light on a Ford Festiva?

There should be a few screws around the housing of the brake light/indicator housing then it is as simple as taking the bulb out and replacing it with the appropriate one.


Will a bb Chevy bell housing fit a sb Chevy?

no yes a bb Chevy bell housing can fit a sbc. but you should remember that 10 in or a 10.5 in bell housing will not fit an 11 in pressure plate. Just make sure that the bell housing will fit the pressure plate and you'll be just fine.


Does engine overfill cause thermostat housing to break?

no. but tightening wrong or the lip of the thermostat trapped under the housing causing un even pressure on housing sure will.


Where is the oil pressure sender on a 1999 Ford F150?

On the 5.4 liter the pressure switch is on the Oil filter housing.


Where is the Thermostat on a 1998 Volkswagen Jetta VR6?

its probably under the battery and housing like the 99 ..so the right side of the block(drivers side)