its suppose to. batt. is to low, engine switch is not good if the lights do not turn off when turning the key
A wrench light on any car means the engine needs attention.
Have the code read, that will tell you.
Yes, they are identical
Disconnect battery for 15 - 20 mintues
To change the check engine light bulb on a 1996 Crown Victoria you need to remove the molding from around the instrument panel. Next, remove the headlight knob and shafts. Locate the light bulb and turn counterclockwise to remove. Reverse directions to replace with a new bulb.
my 1993 crown vic shut off with out warning while at stop light only once in a while
When the check engine light is flashing , it means that an ignition misfire has been detected
Not positive which one but it sounds like a computer or sensor problem
In a 2007 Ford Crown Victoria : In the Power Distribution Box ( which is " live " ) located in the engine compartment near the battery ( mini fuse # 2 is a 20 amp fuse for the spot lights on police vehicles )
The only way of knowing that is to use a code reader and look up the code that you get.
on my 98 crown vic you have to push in the head light switch
On our crown Victoria we had an intermittent check engine light with the error codes "bank 1 and 2 too lean". I tried replacing the fuel filter with no luck. A short while later I had a intake manifold crack and had to get it replaced. My mechanic cleaned the MASS AIRFLOW SENSOR and this seemed to fix the check engine light.