What cylinder? Master (brake) cylinder? Rear Brake cylinder? Lock cylinder?
This is an easy one... Is the fluid green? if it is, it's coolant.. if not, its brake fluid.
How do you change the heater core on a 1989 Oldsmobile Cutlass Ciera? or where can I get the Info on replaceing it
Lift the car on a jack, remove the wheel, the brake shoe and disk. Next put on the new brake disc, put the brake shoe where it belongs, put the wheel back on and lower the car to the ground.
An exploded view of the heater controls for a 1989 Olds Cutlass can be found in the Cutlass service manual. The manual can be found at most auto parts.
Remove pad caliper, then caliper holding frame. Disc will come off now. -Re-assemble in reverse order.
Well i recently just replaced my 1989 Oldsmobile Cutlass Calais S 2 door Heater Core. Man is it a Job! You have to dismantle the center console including the parking brake and radio to get to the heater core. once you pull all the plastic/fake leather away its pretty easy. Well i recently just replaced my 1989 Oldsmobile Cutlass Calais S 2 door Heater Core. Man is it a Job! You have to dismantle the center console including the parking brake and radio to get to the heater core. once you pull all the plastic/fake leather away its pretty easy.
Check the brake light switch. It's under the dash, connected to the brake pedal. If it's adjusted wrong or faulty, it could cause the brake lights to stay on. If you can use a meter and tell that the brake light switch is ok, next test the turn signal switch. Sometimes they short out and leave the brake lights on. You'll have to pull the steering wheel to do that.
In the fuel tank
is it hard to change brake pads on a 1989 BMW 735i
You can adjust your 1989 Chevy Corvette emergency brake into different ways. The emergency brake will have an adjustment bolt on the brake pad. The emergency brake cable can be adjusted to shorten or lengthen the cable.
The 1989 Lincoln Continental brake booster is located on the firewall in the engine compartment. The brake booster will be on the drivers side of the firewall.
In the oil pan
Where the stick is.
59 Liters or 15.59 Gallons
If both brake light bulbs fail to come on when the brake is depressed I'd check first to see if there may be a fuse that controls the brake light circuit. If there is no fuse and/or the fuse appears to be okay, the most likely culprit is a faulty brake light switch. This switch is located up and behind the brake pedal. There is a plunger that moves in and out acting as a switch when the brake pedal is depressed. It is this switch which possibly may be the culprit.
Look above the brake pedal on the rod that holds the pedal. There is a button that engages when you depress the pedal to activate the lights. Your parts store will have a replacement and can show you how it is attached.
Why is the electric coolant fan in your 1989 Oldsmobile cutlass cierra not working?
As long as the bolt pattern is the same and the spacing is the same (4.75") you can swap rims. If you have 14" steel rims you can put 15 or 16" Aluminum rims on but do all 4 other wise the speedo will be off. Also front wheel drive wheels are not the same as rear wheel drive. So put the right ones on.
You add tranny fluid right into where the dipstick is
By the fuel tank , left side where the filler tube is.