0
Why does your 1993 crown vic die when you put it into drive and idle hard?
Wiki User
∙ 13y ago
Clean your idle air control valve near the throttle body with electrical parts spray cleaner.
It can also be a vacuum leak. This car is 17 years old. Replace all under hood vacuum lines. Replace them one at a time as to not bet confused.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Engine idle problem in 1995 ford crown Victoria?
my 1993 crown vic shut off with out warning while at stop light only once in a while
Is the more power-hungry components such as the monitor and the hard drive are put in idle?
hibernation
Can you drive with a vacuum leak?
Depending on the severity,yes,it will may run rough or idle hard
How do you adjust the idle with fuel injection on a 1999 Crown Victoria?
You don't. The Idle is controlled by the ECM. There are no idle adjustments
What causes your truck to idle high when started and causes it to shift hard when put in reverse or drive?
The increased idle when started is normal, all properly working cars that aren't ancient will do it. As far as the hard shift goes, your tranny.
A friends 1993 Mazda 626 makes a clicking noise around the engine not on startup but minutes into the drive and when idle why is this?
Could have a bad motor mount
What are 1993 ford escort fuel idle problems?
Idle speed control or Idle air control.
What are some steps to prevent mechanical drive failure?
Don't let the computer turn it off when it is idle, the constant spin-up and spin-down really wears on the bearings, shortening the hard drive's life. The bearings in a hard drive were designed to be constantly spinning.
How do you adjust the idle speed of a 1993 jeep wrangler the idle is set to high?
Idle is computer controlled and can NOT be adjusted.
1993 Buick Skylark?
won't idle
1993 Mazda Mx6 2.0 will not idle and hard to start?
broken air intake after the air filter and the mass air flow censer. connects to throttle.
Where is the idle screw for a 1993 Mercury Tracer?
There is none. It is electronic. Try replacing the idle motor.
