Same thing happens to mine it could be the wiring off the ingintion module under the bonnet back of the turbo manifold close to were the wiring comes from the ignition into the under bonnet left hand middle just check to see if the wiring is okay
Whenever they get REALLY yucky, or ripped apart.
12 volts whenever the computer has actuated the asd relay.12 volts whenever the computer has actuated the asd relay.
press start click computer then look for it
Start the answer off. It's probably the idle control valve that needs replacing. It's a silver cylindrical device near that's easily replaced yourself. You can get a new one for about £120 from Vauxhall or a second hand one for about £20-30 from a scrappy.
it might cause an virus !
On a Chrysler vehicle the engine computer sets P0700 whenever the transmission computer has detected and set a fault. You will need to have transmission codes checked to know possible causes.On a Chrysler vehicle the engine computer sets P0700 whenever the transmission computer has detected and set a fault. You will need to have transmission codes checked to know possible causes.
Most of the time rough running and stalling is due to vacuum leaks. There is more of a load on the engine when it is in gear, so that lends itself to stalling out. When I look for vacuum leaks, I have the engine idling (maybe you need a friend to keep it from stalling) and then spray carburetor cleaner around the various hoses & gaskets that could be leaking. Any increase in the idle speed would be an indicator that you have a leak in that area.
they have a degugger and a compiler whenever they run a compiler, it brings outs the faults to the programmer an dhence they get aware of it and get rid of their mistakes
Its a computer saying something that isn't straight forward
You subscribe to her on YouTube
How often you should change your air filter depends on how much you use it. If your air conditioner is not blowing enough air. That is generally a good sign that it needs to be replaced. After you replace it, continue to check it regularly and replace it whenever you think it needs to be replaced
Whenever a component is removed, it sould always be torqued to the proper specs when it is replaced.