Want this question answered?
It is under the air box. First remove the air box, then move the coolant reservoir to the left, remove the brace, then you have access to the cover of the pcm.
On my 2001 Aztek, I could pull the key out when driving. To change the ignition without removing the steering wheel, take the two screws out from underneath the covering behind the wheel. Not the screws on the steering wheel. The cover will lift up but won't come off. Take an Alleen wrench and feel for the hole on top of the ignition (it will be a tight squeeze), and push in. I should also say remove the black or gray cover on the ignition switch (where the key goes in). Once you find the hole and push down on it, the ignition switch will come out.
To replace a Pontiac Grand Am bumper cover, start by taking out either the three bolts on the side of the fender or in front of the wheels. Remove the top pushpins to remove the cover. Push back the two pins for each headlight, and pull them up. Unplug the lights. Then, get the replacement bumper, and snap it into place like the previous one.
You have to remove the tail light lens cover from inside the trunk- there are about 6 nuts holding it on --the whole cover comes off and bingo there are your lites for the Pontiac emblem that lights up!! There are no lights persay just for the Licence plates on my 96 Sunfire and I assume the same on a 98
where is valve cover located on a 2001 Pontiac Grand-Am 4 cyl
no
You can access the backup light on your Pontiac from the trunk compartment. Remove the backup light cover. Take hold of the backup light connector, push in and turn at the same time. Do the same with the backup lightbulb. Reverse the process to install the new lightbulb.
What do you mean by headlight cover?What are you trying to do?JW
IT is in the sun
Its in the front valve cover .
Pontiac PVC Valve is located on the Driver's side rear valve cover.
you can cover it with a front end car Bra