0
This can stem from electrical problems. It is hard to diagnose from so little data. But giving the problem, if it does this going from Neutral to other gears as well, then it is most likely a problem with your transmission or torque converter fluid pressure being to high. It can also be caused from an exceeding low engine idle, whos torque may not be enough to keep running when the trans applies pressure via the torque converter. It is advised to have it looked at by a licensed repair shop before costly damage is done.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
When you put it in reverse it make a noses and will not go anywhere but you put it in to neutral it will stop?
well it depends if your wanting to go backwards then you put the car in reverse . or if your wanting to stop then you put the car on neutral.
What is it when 99 infiniti g20 shuts off when putting it in reverse or making a stop but drives fine after car is warmed up for at least 10 minutes and is also worse when its cold out?
I have the same exact problem.
Why does the check engine light come on after putting car in drive and reverse several times?
You have to get the engine looked at.
When putting your car in reverse or in drive the engins bangs like it is loose what is wrong?
Check your motor mounts.
Why won't my car go to park or reverse when I stop?
You have to change the gear. It won't do it by itself.
Will the shifter soleinod stop the car from going in drive reverse?
More than likely - no.
What causes a car to jerk before putting it in reverse?
AnswerA loose nut behind the wheelcheck transmission fluid level if automatic
When do you stop putting a child in a car seat?
its generally at 4'9" for their safety but it also depends on how old they are.
How do you troubleshoot the car dying in reverse and at stops?
Have a 1990 Ford Tempo GL, The car dies when you put it into reverse or you come to a stop. have replaced plugs, wires, Idol sensor, and cleaned the injectors. Its still doing it. Have a 1990 Ford Tempo GL, The car dies when you put it into reverse or you come to a stop. have replaced plugs, wires, Idol sensor, and cleaned the injectors. Its still doing it.
How do you put a Vauxhall into reverse?
Like any other car, come to a stop, clutch down and select reverse! Vauxhall cars have a lock on the reverse, lift the ring under the gearknob before attempting to select reverse or it will go into 1st.
Why would a car just stop running when you are in reverse?
Type your answer here... it is possibly a torque converter problem or transmission faulty
How do you unfasten a bra?
It's like putting it on, but in reverse.
