0
It is probably the speed sensor. It is located on the transmission and sends an electrical signal to the speedometer.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Is the speedometer electronic on a 2004 Chevy Venture?
Yes it is.
Where can one purchase a 2004 Chevy Venture in Florida?
A 2004 Chevy Venture can be purchased at any Chevrolet dealership in Florida. The Auto Trader is also another source to purchase a 2004 Chevy Venture in Florida.
Where is the pcm located on a 97 Chevy Venture?
Where is the pcm in the chevy venture 3.4 2004
How do you change back brake drums on 2004 Chevy venture van?
How do you change rear brake drum on a 2004 Chevy Venture?
Unlock code for 2004 Chevy Venture?
5f041kg89hg51035
Speedometer does not work on 2004 Chevy Venture?
if the speedometer is bad, the dash cluster has to be replaced. this usually done at the dealer because the cluster has to be programmed with software to function correctly. the dash cluster are usually between 200.00 and $250.00 and no more than $100.00 in labor
Does a 2004 Chevy Venture has a timing belt or chain?
The 3.4 litre V6 engine in a 2004 Chevrolet Venture has a timing CHAIN
When to replace 2004 Chevy Venture timing chain?
The best time to replace a 2004 Chevy Venture timing chain is when it becomes weak or broken. It is not something that needs replaced routinely.
Acuator valve replacement for heater 2005 Chevy venture?
my heater fan in front of my 2004 chevy venture van wont work
How much to replace Hub and Tie Rod on 2004 Chevy Venture?
The cost to replace hub and tie rod on 2004 Chevy Venture is about $100. However, this cost may vary depending on where it is done.Ê
Where is the radiator drain plug on a 2004 Chevy Venture?
The radiator drain plug on a 2004 Chevy Venture is located at the bottom, left side of the radiator. It allows for the coolant to be quickly drained during maintenance.
How do you change the thermostat on a 2004 Chevy Venture?
The thermostat on a 2004 Chevy Venture is changed by draining the radiator, removing the upper radiator hose, and unbolting the thermostat housing. The old thermostat and gasket can then be removed and replaced.
