answersLogoWhite

0


Best Answer

I would imagine that the tranny was not inserted correctly. In order to do this, you must use the Poker.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why doesn't transmission work after replacing engine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is the over the counter transmission additives really work and will in damage transmission?

by replacing the bad gasket / seal


How small gas engine work?

it doesnt


Does Cheat Engine work in Second Life?

no it doesnt


How does a rotax engine work?

A rotax engine works on smoke, when the smoke comes out it doesnt work anymore!


Can a hemi engine and transmission out of a charger or magnum be put in a 2003 dodge ram?

The engine may work, but the transmission is not the same. With enough time and money it may work, but it won't be easy.The engine may work, but the transmission is not the same. With enough time and money it may work, but it won't be easy.


Why does your car wine when you step on the gas?

It would be your cerpentine belt that runs our "extras" on your engine or your transmisson. Best thing to stop it would be to change the belt under the hood on the engine. If that doesnt work change your transmission fluids.


What turns the drive shaft that does the work?

The engine turns the transmission then the transmission turns the driveshaft.


How do transmission synchros work?

Synchros in a manual transmission are used to slow down the gear before it is engaged so it doesnt grind


Can a 502 Cadillac engine work with a 5 speed transmission?

In theory, if you can find a transmission housing, flywheel, and clutch that will attach to this engine.


Can the car work if the fuel pump doesn't work?

NO....if Fuel pump doesnt sent fuel to engine...engine cannot combust...


Will a transmission from a 98 Taurus with a 3.0 derictech engine work with a 97 taurrus transmission?

Yes


How do you change a rear main seal on a 1992 Seville?

Either pull the engine or the transmission. Before going to the trouble, check to see if replacing the seal will work out. Open the oil cap with the engine running. Place your hand over the hole and see if there is pressure (called blowby). If pressure is building inside the engine it will press on the oil seal and cause it to fail. Replacing an oil seal in an engine that has blowby is useless since it will fail again.