Want this question answered?
Connect the Positive + battery cable to the positive + battery post first. Then connect the Negative - cable to the negative - battery post.
Unhook the cable from the Cavaliers battery. Find the opposite end of the cable and pull it out. Fit the new cable in following the old cables route. Connect the non battery end of the cable, then hook to the battery.
un-hook the negative battery cable from the battery for 15 minutes and then re-attach cable.
Answer Red cable (+) goes to starter solenoid and Positive side of battery Black (-) cable goes to engine ground. When disconnecting a battery always disconnect the ground cable from the battery first. When connecting a battery always connect the ground cable to the battery last.
Audio battery???? If you mean Auto Battery then Red Positive (+) RED cable goes to Positive (+) post on battery. Black Negative (-) cable goes to Negative (-) post.
Maybe you mean cable. You can bolt a car battery cable to the block of the engine. Usually under the exhaust manifold.
With any battery on any car, the negative cable is ALWAYS the first off and last on.
To hook up jumper cables, attach one cable from the negative post on one battery to the negative post on the other battery. (These usually are marked "-" and have a blacl cable attached to them.) Attach the other jumper cable from the positive post on one battery to the positive post on the other battery. (These usually are marked "+" and have a red cable attached to them.)
you hook the positive cable,(usually the red) to the positive battery terminal first then you hook the negative cable(usually black) to the negative terminal if you hook it the other way you can get sparks or arcing that can cause damage or a fire PS: if both cables are same color, the negative cable is the one bolted to the frame or the engine.the poitive is bolted to the solenoid or starter
First disconnect the negative battery cable, then disconnect the positive battery cable. Batteries usually are held down by a clamp or bracket. Unbolt or unhook the bracket. and remove the battery. Installation is the reverse. Hook negative cable last. HTH
Connect negative (-) black cable first. Then connect positive (+) cable last. You will see a + and a - next to the posts. Hook up positive first, negative last.
You hook the positive cable to the red connection just inside of the air cleaner box. You hook the negative cable to the nut on the left strut tower.