0
Try replacing the master cylinder and slave cylinder cost under hundred, it's helped me before when my clutch stuck....However if that doesn't work then it may be the pressure plate which requires dropping the transmission...
I have the same issue and am doing the process of elimination, just finished replacing the slave (cost me like $13), now I'm replacing the master cylinder (cost me like $41) but striped the bolt on the pipeline connected to cylinder....FML
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Why is the clutch petal on my 1993 Subaru legacy L stuck to the floor?
your clutch cable located at rear of motor is snapped, bro autopartswarehouse.com has one for $50 bucks, bro easy fix
2005 Sunfire clutch is stuck to the floor?
Well, we need lots more information here. Is the clutch pedal actually "stuck" to the floor? In other words, can you NOT lift the pedal up to the normal position? OR, has the clutch pedal "fallen" to the floor due to no resistance from the clutch?
Why is the clutch on your 1998 subaru legacy outback stuck to the floor?
Your clutch cable snapped. It should be an easy fix.
Have a Volvo 850have some clutch problems the clutch pedal is stuck on the floor and cant enter into the gears?
Replace master and slave cylinder, then bleed hydraulics.
What is the problem if your 1988 Honda Accord is stuck on third gear and does catch the clutch when you turn it on?
The clutch throwout bearing/mechanism is malfunctioning. This isn't a job for a shadetree mechanic. Best to have it done professionally.
What could be wrong with my1995 Camaro 5sp clutch went to the floor and it is stuck in neutral?
it might be the slave cylinder
What can the problem be when a 91 Nissan sat for a long time and the clutch pedal is stuck to the floor?
check your clutch fluid lines and your clutch fluid and also bleed the clutch and it should work just fine mine did the same thing and i had to replace a clutch line that was pinched
Why is my clutch pedal stuck to floor after installing new clutch master cylinder on a 1983 Nissan truck?
u must bleed the system . fill the clutch master cylinder with dot 3 brake fluid and keep an eye on it when bleeding so it wont run out ,have someone pump clutch pedal 3 times and hold to floor and oper bleeder valve on clutch slave cylinder till no air comes out then go to clutch damper and do the same ,follow clutch line fromclutch master cylinderto damper.
Why would the clutch be stuck to the floor when your foot is removed from the pedal on a 1988 Porsche 944 along with a good size spot of fluid under the left front section of the car?
obviously you have a clutch line or slave cylinder leak.
Why does the clutch pedal go all the way to the floor on your 1990 Rx7 Mazda?
the piston in your clutch master cylinder is stuck in the cylinder body. you need to remove, hone out, rebuild or buy (best) a new one. on line about $50.
Why wont your shifter go in gear after installing clutch kit on a 1989 ford ranger truck?
if you had this same problum befor u installed the new clutch the trans is stuck betten gears if you can push the clutch in and the veh will roll andyou cant shift it you just mite have put the clutch disc.in back word now till me dose you clutch peddle stay on the floor when you push it in?
What do you do if your clutch gets stuck in the down position in a 1998 vw golf?
Happened to mine if your brake light flashed before like flickering it might be your brake fluids low add some then move your clutch petal half pumpls get the air out. Its a hydrolic so it should pop back up by itself one the air is out and the fluids replenished. Hope this helps
