Not sure where you are seeing the gas "spitting" out. I found the float was sticking on my carb (12.5hp) and allowing the cylinder and crank case to fill up with fuel. It was allowing a constant stream of fuel to flow through the carb and into the engine. When I turned it over, the fuel sloshed back up through the carb. Had to drain the oil/gas from the case and pull the head off the clean up the cylinder. Of course, I also pulled the carb off and gave it a fresh cleaning, making sure that the float was no longer sticking. The mower sat all winter and apparently the fuel varnished the carb enough to "sticky" it up.
Honda or husquy cr 125
The carb bowl drain nut is located on the bottom of the carb.
120 main jet on a 28mm carb
snug them don't tighten them
125 with a carb or TBI, 175 in magnum MPFI form
mine had a 2 barrel carb and had 125 hp with the 350
there is a nob on the carb just play with it until you get it adjusted
will a 110 carb make a 125 pitt bike go slower
take the carb out give it a clean if not then the air filter lol
play with the carb and or change the plug gap accordinglly?
Yes it will fit, I have a 98 carb and my 86 model kx125
bore carb out to 50 mm drill main jet to180 remove air filter